Starting with great mentors is awesome -- Really looking forward to following your build. Great video -- You covered a lot in eleven and a half minutes!
The DRDT2 needs to go fully over centre of you will end up with underdimpled holes and a crappy line of rivets visually. Have a read of the manual. With no metal in between the dies, the nut should be adjusted to there is a tiny bit of flex in the steel arm of the tool.
Starting with great mentors is awesome -- Really looking forward to following your build. Great video -- You covered a lot in eleven and a half minutes!
Thanks so much for your support!
Do you think I’m a medium or large in Vans T-shirts? 😎
Good to have experience in your camp
Looking forward to the process
Cracking Video :)
Learning so much about riveting I didn’t know didn’t realise there was so much to it
Me too brother 🤓
The DRDT2 needs to go fully over centre of you will end up with underdimpled holes and a crappy line of rivets visually. Have a read of the manual. With no metal in between the dies, the nut should be adjusted to there is a tiny bit of flex in the steel arm of the tool.
Thanks for tip!
I will definitely need to be well read up on it by the time i’m up to drilling and dimpling fresh pieces. 👍
Only 18,000 holes left to drill and debur 😊
Eating the elephant 1 bite at a time brother 😉
Some use broom handle to peel. blue plastic. Like on the skins
That’s not a bad idea. I’ll try that.
Thanks Bob! 👍