dumb question..when using the m2 clamp, where it says line 1 or line 2, do you stop in front of line or behind it? i ask because i have cut a few keys already and they seem a tad bit off, if i push the key in further it works better. I assume to put key tip at front of line 2 on both sides..but to be fair, the keys i cut were for older cars and didn't use any houdini lube. Also i am not filing down the key after like i would after usng blitz.
should i level the tip to the very edge of machine using the should stop part so its flat at the edge or on the line? alot of these videos its at an angle so its hard to see exactly where its stopping
dumb question..when using the m2 clamp, where it says line 1 or line 2, do you stop in front of line or behind it? i ask because i have cut a few keys already and they seem a tad bit off, if i push the key in further it works better. I assume to put key tip at front of line 2 on both sides..but to be fair, the keys i cut were for older cars and didn't use any houdini lube. Also i am not filing down the key after like i would after usng blitz.
should i level the tip to the very edge of machine using the should stop part so its flat at the edge or on the line? alot of these videos its at an angle so its hard to see exactly where its stopping
I just stop them at the where the tip is over the line. the machine indexes it.. if its to far off the machine will give you an error