THEMOWERMEDIC1, I am looking to find a set of torx bits such as the one you used in this video. Could you steer me in the right direction, please? I need some bits that will not twist in two when confronted with a tight or stuck screw. Thank you. I am also repairing a backpack blower the owner bought thinking it had a 4-stroke engine. He had been running straight gasoline in it until it seized up. I cut the cylinder off and removed the piston, wrist pin, and wrist pin bearing and am going to replace them.
Nice one again. The heat and freezer trick definitely works. Used to do it in the UK when fitting new wheel studs to the hubs on our coaches.
Great job MM1. Always nice to watch what you have going on. Have a great day my friend!
You can make a simple puller from threaded bar two washers and two sockets but each to their own, some just love backyard ways don't dey Cletus.
Crank was junk cledus
Can you do a video on how identify if u have a bad crankshaft seal and fly wheel seal
Thank you mower medic
The crankshaft case is made of aluminum or cast iron?
How did you remove the cover of the crank shaft before starting the video?
I love my Husqvarna replica case splitter works amazingly on my chainsaws
Me too I got mine from HL supply
Sweet
THEMOWERMEDIC1, I am looking to find a set of torx bits such as the one you used in this video. Could you steer me in the right direction, please? I need some bits that will not twist in two when confronted with a tight or stuck screw. Thank you. I am also repairing a backpack blower the owner bought thinking it had a 4-stroke engine. He had been running straight gasoline in it until it seized up. I cut the cylinder off and removed the piston, wrist pin, and wrist pin bearing and am going to replace them.
Is there any way to separate the connecting rod from the crankshaft
Cutting torch
how did that crank get messed up?
th-cam.com/video/ab9kyE-YkdA/w-d-xo.html
The spot on crank shaft where the flywheel key goes messed up
You’re gonna change the crankshaft oil seals too, right?
Absolutely
That is easy if it is brand new
Then how do you remove crankshaft bearings?
This video is about crank shaft removal