Your videos are amazing! Keep it up. it helps people learn about these and even opens up the ability for people to feel comfortable in customizing them.
Hello! The tire is just hooked, so you can pull it off. It is attached very tightly, so please use tweezers to remove it gently. Of course, be careful not to lose the tire.
Thank you for sharing your knowledge. I am waiting for mine to arrive and was concerned about battery life and replacement. Please show us if you do a replacement thank you.
Replacing the battery is not as difficult as replacing the motor. Be careful not to break the electronic base when peeling off the red glue. If you grip the electronic base too tightly, it may break. When removing the wiring with a soldering iron, be careful not to touch the other solders. It is a good idea to use double-sided tape to secure the new or battery. Please work calmly. I hope the exchange will be successful. (The electronic base is prone to breakage at the narrow point around the rear wheel. If it is damaged, it is difficult to repair. You can't even buy parts. Please work with caution.)
@@umenyan0049 thank you. More than likely I will not even try when the time comes ha ha. Thank you for responding so quickly! Have a great day and I will be sure to give you all thumbs up on your videos…
@@umenyan0049 I will I’m sure can’t wait for it to get here! Don’t want to take up too much of your time, so thank you again and may peace and blessings always be with you.
@@umenyan0049 thank you. What about modding the original trasmitter? perhaps limiting the throttle trigger potentiometer with a resistor so that it acts always as "gently" pressed?
@@dawned_instruments I can't really recommend it. You can buy a P32 transmitter for about $27. It can be used for all turbo racing. It also has various settings for throttle, dual rate, etc. You can also register many turbo racing and keep the settings. I recommend the P32 transmitter.
В основном, замена внутренних деталей требует разборки. Детали небольшие, но кузов больше, чем у других турбогоночных автомобилей, поэтому работать было легче. Будьте осторожны, чтобы не потерять детали при разборке.
Or maybe Is it possible to install a 2-pin connector on the positive and negative wires of the battery so that I can quickly replace it with another already charged one and continue playing? thank you and sorry for the many questions ..
@@gianvitorusso7254 Hello. I tried the smallest 2 pin connector I have. I was able to put just the connector in my car (C72). However, the cord routing and durability is an issue. I might be able to do it.
Your videos are amazing! Keep it up. it helps people learn about these and even opens up the ability for people to feel comfortable in customizing them.
Thank you. I am honored to help you.
Thank you so much for this instructive video. I have several now and being able to disassemble and reassemble them will be nice!
I am honored to be of service to you.😊
And a second question...
Are the wheels enough soft to have movements with the car weight?
Hello.
There is no air inside the wheel.
The tires are all rubber.
Therefore, the tires are not deformed by the weight of the car.😊
An absolute great and informative video sir!
Thank you very much. I am glad to hear you say so.😀
hi friend, can you help with how to remove the tire to clean and remove the dust?
Hello!
The tire is just hooked, so you can pull it off.
It is attached very tightly, so please use tweezers to remove it gently.
Of course, be careful not to lose the tire.
where to I find parts for this think?
AliExpress
Shenzhen Newstone Store
a.aliexpress.com/_ooe8Oub
😊☝️
Thank you for sharing your knowledge. I am waiting for mine to arrive and was concerned about battery life and replacement. Please show us if you do a replacement thank you.
Replacing the battery is not as difficult as replacing the motor. Be careful not to break the electronic base when peeling off the red glue. If you grip the electronic base too tightly, it may break. When removing the wiring with a soldering iron, be careful not to touch the other solders. It is a good idea to use double-sided tape to secure the new or battery. Please work calmly.
I hope the exchange will be successful.
(The electronic base is prone to breakage at the narrow point around the rear wheel. If it is damaged, it is difficult to repair. You can't even buy parts. Please work with caution.)
@@umenyan0049 thank you. More than likely I will not even try when the time comes ha ha.
Thank you for responding so quickly! Have a great day and I will be sure to give you all thumbs up on your videos…
@@bigl546
Thank you. Have fun with Turbo Racing.
@@umenyan0049 I will I’m sure can’t wait for it to get here! Don’t want to take up too much of your time, so thank you again and may peace and blessings always be with you.
A question about wheels...
Have wheels air inside?
Thanks
A good video ; thank you :-)
hello, is there a way to reduce speed, going lower than 20% permitted on the transmitter?
The P32 transmitter (sold separately) allows adjustment from 0% to 100%.
Select EPA and press and hold the switch to call up "TH" and select %.
@@umenyan0049 thank you. What about modding the original trasmitter? perhaps limiting the throttle trigger potentiometer with a resistor so that it acts always as "gently" pressed?
@@dawned_instruments
I can't really recommend it.
You can buy a P32 transmitter for about $27.
It can be used for all turbo racing.
It also has various settings for throttle, dual rate, etc.
You can also register many turbo racing and keep the settings.
I recommend the P32 transmitter.
Вы меняете опору? Я правильно понимаю что нужно полностью разобрать чтобы поменять пластиковую опору на которое крепиться колесо
В основном, замена внутренних деталей требует разборки.
Детали небольшие, но кузов больше, чем у других турбогоночных автомобилей, поэтому работать было легче.
Будьте осторожны, чтобы не потерять детали при разборке.
There Is enought space for replace battery with a bigger one like 200 mah
Thikcness 6mm width 12mm lenght 30mm? Thanks you
Is it a car battery?
Or the transmitter battery?
I don't see any space in the car body.
The transmitter grips are the same as the mini cooper.
@@umenyan0049 insider the car..i would like to increase gaming autonomy for rent the cars for racing in my club bar
Or maybe Is it possible to install a 2-pin connector on the positive and negative wires of the battery so that I can quickly replace it with another already charged one and continue playing? thank you and sorry for the many questions ..
@@gianvitorusso7254
Hello.
I tried the smallest 2 pin connector I have.
I was able to put just the connector in my car (C72).
However, the cord routing and durability is an issue.
I might be able to do it.
@@umenyan0049 thanks...i ordered the turbo racing c81 e when arrives..i Will try
Do you know what is that wire with an unconnected end next to the battery?
White code.
That is an antenna😊
ライトをつなぐコネクタピンを折ってしまいました（泣） 修理可能なものでしょうか
基盤のピンを折ってしまったのですか？
ライトはコネクター付で販売してますが基盤を損傷したらアウトです。
何とか折れたピンをハンダ付けするか折れた箇所にコードをハンダ付けして途中ににコネクターを入れて使う事になるとおもいます。
まずはコネクターの修復から試して下さい。
他の部分を焼かないよう注意して下さいね。
@@umenyan0049 ご教示ありがとうございます。小学生の息子が興味本位で外してみたみたいでライトが付かなくなったといってみてみたら根元から割れていました。
折れてピンはすべて取り出せたので、細かい作業ができるかどうか自信ありませんがやってみます。ご返信ありがとうございました。
お見事 (*’ω’ﾉﾉﾞ☆ﾊﾟﾁﾊﾟﾁ
お役に立てれば幸いです。