Farrier Hammer Handle Replacement

Roy Bloom, APF CJF works through the steps involved in replacing a hammer handle. The process is illustrated with Bloom's forging hammers but is effective for any hammers. For more information, articles and videos visit www.farrierproducts.com.

[@gregoryv.zimansr4031]

This was a well done and organized presentatiuon. I have replaced many handles and over the years I have learned to replace them in almost the same way. After I remove the old pieces from the hammer if there is room I reuse the old metal wedge again so that I have 2 wedges . I also will use a file or grinder to dress the end of the handle where the wedges are set in because the end is usually rough. I also use a grinder to dress the other end of the handle so that it is chamfered. this helps reduce splitting or cracking the end of the handle.

[@aaronmurphy5060]

cool, thanks for the no nonsense vid. I've done a number of handles my self previously, but it is always nice to check that your not missing something when it has been a while.

[@FarrierProducts]

We appreciate the comments. Roy always does a solid presentation.

[@moayadsaeed]

very informative, nicely presented. thank you.

[@243WW]

Simple and clear.

[@legalsolutions07]

You made that look too easy:) Do I need to match the cavity shape of my existing hickory hammer handle to the shape of the replacement handle head, or will any hickory hammer handle work on any hammer? Should the wood wedge and metal pin come with the replacement handle, or are these purchased separately?

[@FarrierProducts]

Sometimes you can find replacement handles specifically for the tool you have. But if not, find one that is larger and you can shape the end to fit. Many replacement handles have the steel and wood wedges included with the handle. That is the case with the Bloom Forge and FootPro hammer handles.

[@kooldjdizzy]

I have seen some hammers that have the handle recessed maybe a 1/16 to an 1/8 below the head's surface with epoxy. Is this something that you would recommend?
I am a tin nocker and I need to replace the broken handles on two of my hammers. Thanks
Don

[@MrYosmitty]

why did you replace a perfectly good handle? lol

[@osityan]

to show your dumbass how to do it ;)

[@myRefuge3710]

My goodness

[@lrodriguez9315]

he couldve just drilled it out without cutting the handle.psssh

[@FarrierProducts]

That's true- just a different way to go at it.