Hi there is easier way to re place it from top dont need to remove any of the tires Just remove the conction huz between air intake filter and the throtel and then stik your hand from the back of the engine yow will see the sensor from there unplag the wair and remove and replaced the sinsor
I just did this today, not sure what the hell the purpose of taking off the tire or the air intake hose like the top comment mentioned, I took off tire first and i couldn’t even fit myself, I took off air intake from the top and it was pointless to me it did not make job eaiser imo so I put the tire back and the air intake hose back and decided to try something else Finally I drove my car on Ramps I purchased from harbor freight, and I have photos to prove it lol and it took me a while to find the sensor I couldn’t freaking find it because it was so damn dirty I could not see the gold, needless to say I was able to get the job done just using the ramps and the socket 1 1/16 and one extensions, hope this helps
You can clear most codes and reset the light but rmoving the positive battery cable for about 5 minutes. But my light went out after I changed the sensor and nothing else
My wife's 2016 200 just had the check engine light. AutoZone probably gave her the code but told her it needed this sensor. I never buy cheap sensors so I ordered it from Rockauto. I changed it out and light turned off. The red oil light never came on or flickered. Im guessing if that is happening its something else and could be more serious
My wifes car oil light randomly would flash and a check engine light. Was on. Swapped sensor and cleared codes have to drive a drive cycle and permanent codes will clear
Im doing it right now with just removing the tire off!! And you dont need anything to pick the red secure thing with my finder just pusshed from left to right and boom!!!! There you have it ....
Do not take any think off the car but the passengers front tire. Look right behind the pully and there it is. Maybe 10 min job. don't purchase it before you get it off there is two different kinds auto zone did not have it o'Reilly's had it cheaper than auto zone. I did not remove the large shield under the car.
I am getting this code on my car now and i am being told they have to do all possible causes before changing the sensor. Changed filter and now telling me $1600 to change oil pump. Am i being taken as a lady or can they just change the sensor and be done?
They are robbing you. They can just change the sensor. Also can diagnose oil pump with sensor removed. Will just pour oil out of the sensor hole if the pump is good.
My 200 recently got a C.E.L. and they said oil pressure sensor at advanced auto parts. So this video should help. Thanks for the upload bro
No problem glad I could help!
Hi there is easier way to re place it from top dont need to remove any of the tires Just remove the conction huz between air intake filter and the throtel and then stik your hand from the back of the engine yow will see the sensor from there unplag the wair and remove and replaced the sinsor
Make a video
That's the way I went about it.
@@kingbebe55tv63 just read what he wrote. It's easy.
You should be a butcher because your just chopped English up to hell. Wair? Huz? Conction? Re place ? Throtel? What does this gibberish mean?
The what? Remove the what?
I just did this today, not sure what the hell the purpose of taking off the tire or the air intake hose like the top comment mentioned, I took off tire first and i couldn’t even fit myself, I took off air intake from the top and it was pointless to me it did not make job eaiser imo so I put the tire back and the air intake hose back and decided to try something else
Finally I drove my car on Ramps I purchased from harbor freight, and I have photos to prove it lol and it took me a while to find the sensor I couldn’t freaking find it because it was so damn dirty I could not see the gold, needless to say I was able to get the job done just using the ramps and the socket 1 1/16 and one extensions, hope this helps
Thanks for the tips!
Where the pictures at currently have my car on ramps
I did it without taking the tire off, same way as this video.
All you need is a 10mm, 27mm, and a small tool, like a trim pick.
2nd time i fix this in 2yrs! Also had to fix on Chrysler TownCountry once. Geeez
Wow
It's got to be a chrysler issue. I have to replace mines again. 2nd time within 2 years
Don't buy AutoZone or O'Reilly's sensors. They are cheap sensors. Either NAPA or Rockauto is all I buy for electrical parts.
And don't buy any more chryslers 🙃
What were the symptoms
Thanks, if this sensor broken, engine will or will not run??
The sensor was bad on ours and we could still drive it but the check engine light was on.
Thanks, I checked today and they discovered it's an air actuator problem, but it's still not running ...
Very very helpful, thanks!
Is it on the left side or right
Well I just snapped the duralast off in the block!
How do you remove the engine light after replacing that sensor do I need to go to a shop for that
You can clear most codes and reset the light but rmoving the positive battery cable for about 5 minutes. But my light went out after I changed the sensor and nothing else
What was the code or symptom that you got that triggered this repair?
Thats what im curious about my wifes car is randomly beeping showing a red oil light. But its random never a light that stays lit
My wife's 2016 200 just had the check engine light. AutoZone probably gave her the code but told her it needed this sensor. I never buy cheap sensors so I ordered it from Rockauto. I changed it out and light turned off. The red oil light never came on or flickered. Im guessing if that is happening its something else and could be more serious
My wifes car oil light randomly would flash and a check engine light. Was on. Swapped sensor and cleared codes have to drive a drive cycle and permanent codes will clear
Will this keep your car from turning all the way over
I took my tire off n I was able to get to my location better 2.7 avenger 08'👍🏽👍🏽
Nice thanks for the tips!
So do you have to take the shield off or can you just take the tire off?
Im doing it right now with just removing the tire off!! And you dont need anything to pick the red secure thing with my finder just pusshed from left to right and boom!!!! There you have it ....
How long did you guys let the car run after replacing it?
And I also lost the red tab 🤦🏽♂️ is it needed for it to function properly?
Car looks good!
Lol thanks
Do you enter the side on the left side of the car not the right side
I used a deep 1 1/16 socket. For some reason it wont catch on the sensor
I have the same issue with mine. Did the rpm go back to normal. Mine stays at 1200 rpm never goes down.
Yeah my rpm is crazy haven't replaced yet
Did you need to drain your oil first ?
No
No
No
Do not take any think off the car but the passengers front tire. Look right behind the pully and there it is. Maybe 10 min job. don't purchase it before you get it off there is two different kinds auto zone did not have it o'Reilly's had it cheaper than auto zone. I did not remove the large shield under the car.
I can’t get mine to fit in after I take the old one out. I can see it go in and turn and nothing won’t go in
How long did you run it for after ?
Doesn't matter
I am getting this code on my car now and i am being told they have to do all possible causes before changing the sensor. Changed filter and now telling me $1600 to change oil pump. Am i being taken as a lady or can they just change the sensor and be done?
They are robbing you blind. They can easily check the pressure and the sensor.
They are robbing you. They can just change the sensor. Also can diagnose oil pump with sensor removed. Will just pour oil out of the sensor hole if the pump is good.
This video help me alot
Does oil come out when I change it
Yes
Why did you have to replace it ?
Check Engine light was on
@@JotaJotaSTI did this take care of your check engine light
🔥🔥🔥🔥🔥
🦾
🎉 Gracias 🎉
2.4L?
Yes
You shouldn’t bottom the sensor out when tightening , im pretty sure for all cars
Where's the damn thing at ?
Watch the video, with your eyes open.
Bro every fucking video they show where it is but never WHERE TO FUCKING GET TO IT IVE BEEN LOOKING FOR 30 MIN.... WHERE?!?!?!?
Lol im dead
whos car is this haha
Parents lol
OMG FIRST YESSSS
Lol nice
Worst demo
Thanks!
That's a helpful comment
Editing is terrible