Its sometimes the its the return of the oil been bloced fore go back in the resovare in the transmission, i have that problem must been a vavlve in the cover or in the hole , not find it out of that in none manual , i remvale the top cover to morrov and take a look
Hi, Sir, Sarfraz from Pakistan.i have a ford 3600 tractor.please make vidoe about ford 3600 hydraulic lever setting and control valve setting . Regards.
It could be a stuck draft control linkage or, I had a similar tight lift on an old TEA20 that had a stuck relief valve. I had to remove and replace it, not an easy job either.
I have a Case doing the same thing, but for now I have found a way to trick it. I ease it back into a tree or dirt bank and hold pressure for 5 to 10 seconds. When I pull off, it’s on the ground. It’s a mystery
Exactly what happened with mine, in fact it wouldn’t go down. Unfortunately the only way to for me to fix it was to remove the cover. You may be able to try and free yours by reaching up though the side covers, good luck!
yea i ended up taking the cover off and i believe the rod was jammed too far into the hole (not sure yet) i set the cover back on and didnt have that roller thing behind the 2 fingers. im gonna put it back together tomorrow and hopefully it works. Thanks for the video and the reply it really helped me!
![[#SHORTS CLIP] ครูอึ้ง กรรมการอึ้ง ฮ่าๆ l ซานิเบาได้เบา l One Playground](http://i.ytimg.com/vi/qeBTuMJs4t0/mqdefault.jpg)
Its sometimes the its the return of the oil been bloced fore go back in the resovare in the transmission, i have that problem must been a vavlve in the cover or in the hole , not find it out of that in none manual , i remvale the top cover to morrov and take a look
David, how long should that rod be as I have a similar problem but I don’t know what the correct length should be.
Hi,
Sir,
Sarfraz from Pakistan.i have a ford 3600 tractor.please make vidoe about ford 3600 hydraulic lever setting and control valve setting .
Regards.
Does anyone know why wouldn't my hydraulic on massey ferguson 35x lift? We changed the oil*
where you able to move the lift Control handle as normal? or was it stuck in the hi position?
The handles would move under spring tension but they couldn't move the levers.
hello my lift of my mf 135 does not want to drop just if it is weight.
anyone have an idea??
It could be a stuck draft control linkage or, I had a similar tight lift on an old TEA20 that had a stuck relief valve. I had to remove and replace it, not an easy job either.
I have a Case doing the same thing, but for now I have found a way to trick it.
I ease it back into a tree or dirt bank and hold pressure for 5 to 10 seconds. When I pull off, it’s on the ground.
It’s a mystery
Mine is stuck and keeps lifting up way higher than it’s supposed to is it that rod? Do I have to pull the cover off to get it
Exactly what happened with mine, in fact it wouldn’t go down. Unfortunately the only way to for me to fix it was to remove the cover. You may be able to try and free yours by reaching up though the side covers, good luck!
yea i ended up taking the cover off and i believe the rod was jammed too far into the hole (not sure yet) i set the cover back on and didnt have that roller thing behind the 2 fingers. im gonna put it back together tomorrow and hopefully it works. Thanks for the video and the reply it really helped me!
Do you know about how much that whole cover weighs