RJ's Lee Loadmaster Priming system- Part 2

แชร์
ฝัง
  • เผยแพร่เมื่อ 24 ธ.ค. 2024

ความคิดเห็น • 6

  • @maryfithen5006
    @maryfithen5006 3 ปีที่แล้ว

    Great shot of your case feeder

  • @LegateMalpais
    @LegateMalpais 12 ปีที่แล้ว

    You Sir, are a life saver!
    Using the LM with LP primer system to load .44mag I came across a huge problem where about 50% of the rounds failed to prime due to a) the case being too loose in the index plate that I solved by placing the sizing die over it, and b) due to the priming pin/rod "wandering about" because of the priming system sitting way too loosely. Using clear office tape I made it snug-tight, now it works almost flawlessly. Thank you for this great tip!

  • @jeromejohnson7653
    @jeromejohnson7653 4 ปีที่แล้ว

    A single piece of electrical tape tightened mine up and it works fine. Such a simple solution for hours of frustration and lost primers.

  • @bill84345
    @bill84345 11 ปีที่แล้ว

    With less wiggle do the primers feed alright or do you have to bump the feeder assembly some

  • @mildot5482
    @mildot5482 9 ปีที่แล้ว

    thanks

  • @mildot5482
    @mildot5482 9 ปีที่แล้ว

    you can send this to Lee