Making two oil nipples for turbo installation
ฝัง
- เผยแพร่เมื่อ 16 ก.ค. 2024
- This time I make two oil nipples for installing a turbo in a tractor.
In this video I use:
- Weiler Matador SV (1972) Lathe
- Schaublin SV-51 (1955) Milling machine
- Solberga (1975) Drill press
Chapters:
00:00 Opening animation
02:04 Opening words from inside a UFO
02:52 Cutting a suitable piece of material
04:59 Turning the outer dimension of the first workpiece
13:28 Making an M10x1 thread
20:33 Cutting the first workpiece to the correct length
22:08 Drilling a hole suitable for the M12 thread
23:41 Tapping an M12 thread
24:16 The pitch of the thread is wrong
25:31 Remaking the first workpiece
27:21 Making an M12 thread with the right pitch
28:03 Finishing the turning of the first workpiece
29:11 Preparation of the second workpiece for the M18x1.5 thread
33:25 Making an M18x1.5 thread with a lathe
35:41 Drilling an 8mm hole through the second workpiece
38:11 Cutting the second workpiece to the correct length
38:40 Turning a suitable section for the rubber hose on the workpiece
41:39 Finishing the second workpiece on the lathe
43:03 Set up of the dividing head and the milling machine
48:33 Milling a hexagon on the first workpiece for the wrench
51:32 Milling a hexagon on the second workpiece for the wrench
54:46 Drilling a 3mm hole through the first workpiece
56:26 Concluding words
58:37 End credits
The video is spoken in Finnish but it has good quality hand written subtitles in English, German and Finnish. - วิทยาศาสตร์และเทคโนโลยี
very good job finno
Hi Esko. looking forward to the knurling tool. Please make a drawing of it :)
Onko tossa nipan renderöinnissä laitettu joku sorvin kuva heijastumaan tosta nipan kyljestä?
Kyllä on. Kaikkeen toi Blender pystyy 😃