[30] B&D Roller Door Remote Erase & Recoding. Clearing the memory and reprogramming
ฝัง
- เผยแพร่เมื่อ 5 ก.ย. 2024
- B&D Power Drive & Roll-A-Pro® Rolling Door Opener. Remote Instructions
Erasing All Programmed Codes:
If the CODE SET button is pressed and held for six (8) seconds whilst the power is turned on the LED’s will blink rapidly for a few seconds to indicate that all programmed codes have been erased.
Coding a Transmitter:
Storing the Transmitter Code
The opener can only be operated from remote control transmitters that have been programmed into its memory.
Up to 64 codes can be stored in the memory.
Press the CODE SET button and release.
The CODE SET LED will illuminate to indicate the opener is in Code Learn mode.
If a valid code is not stored within 15 seconds the opener will exit Code Learn.
Press the transmitter button of your choice.
The CODE SET LED will flash.
Press the same transmitter button again.
The CODE SET LED will illuminate for one second then go out.
The transmitter button is now coded - press to test.
It's gonna happen! Your garage door, gate, or window shutters will need fixing someday. Prepare now with my DIY video tips! Subscribe and join the community!
Plus it motivates me to make more videos (it’s free) tinyurl.com/garagedoorsYT
Thanks for this, so clear and easy to follow!
You're very welcome! ☺️
Thanks! Worked a treat!
You're welcome!
thanks a lot mate. very helpful
You're welcome! ☺️
Thankyou so much………….👍👍👍👏🏻👏🏻👏🏻🙏
Most welcome 😊
thks for the vid. does this method applies to the gdo 11v1 garage door opener?
Thanks 👋🏻 the GDO 11 is ATA I think which is usually power off, then hold door code while turn power back on
How do you reset the service alert again?
Usually reset limits or hold the set button
red light keeps flashing when I'm programming it doesn't stop flashing
Any idea how to replace the manual pull cord on these units, mine has broken and cable has come out????
If you can access the back of the motor you’ll need to remove the rear top cover, rear centre cover, front light cover and circuit board screws. Then you can feed another string up from the bottom to the link on the motor clutch
Hey mate, I've got the slightly older b&d firmamatic with the same new remote, but when I'm pushing the button on the remote their isn't the little red light showing that it's getting the signal, do you have any tips on how to solve this?
If it’s not getting a signal it’s usually not compatible.
- I think blue or green antenna wire for red remotes
- if it’s got a white antenna wire it will be the older remotes
Hi mate please help! My red light on the motor doesn’t stop flashing! And I can’t press any button! How to stop the red button flashing?
Which light 💡
Same operation, I can not clear memory, what should I do?
Should work with this procedure or maybe a fault
Dam tried this it didn't work for me.
Same remote ? If you press any button you should get a light come on the motor to make sure it’s compatible
@@rollerdoors Yes same remote and motor. I will call a service person