Lid Lock bypass fix Maytag whirlpool washer

แชร์
ฝัง
  • เผยแพร่เมื่อ 17 ม.ค. 2025

ความคิดเห็น • 5

  • @kingstonday3345
    @kingstonday3345 ปีที่แล้ว +1

    thank you. this is an on & off problem for me on a regular. this is the only video that made sense & that i could comprehend as a non mechanical person. thank you

    • @cartalk5585
      @cartalk5585  ปีที่แล้ว

      I haven’t used the bypass in a while myself. I have on occasion had to bump it with my fist when it is time for it to engage the lock. I have taken my finger nail and pulled the little plastic plunger out and pushed back in multiple times. Recently I have also had some trouble with the plastic plunger not disengaging at the end of the cycle. I have bumped it with my fist on top of the door but above the lock and it disengages.

  • @davissunglasses
    @davissunglasses ปีที่แล้ว

    After tricking the switch for a while it’s back working normal again. I have hit it with my fist on the lid about the time it is supposed to trigger, and that has worked also at times.

  • @johnniewilliams5371
    @johnniewilliams5371 6 หลายเดือนก่อน

    Thank you, but just remove the lock part from the lid and place in the hole it works fine goes thru all cycles. Put in safe place and that's it no wires cut just remove 2 screws that hold in and place inside like it would normally look close lid if like or leave open and it will work fine.

  • @johnniewilliams5371
    @johnniewilliams5371 6 หลายเดือนก่อน

    Must use this piece every time tho so place with in baggie ANF with wash utensils bleach or whatever you have and boom!