I DIDN'T see the moment when you took off the top of the electrical injector from the cover, I can see you cut off the video in that moment. Why? Because it's really hard to remove.
@@carfix1993 for the fuel line injector tight 22nm is this standard for other like Innova thank you new subscriber watching from Al Khafji Saudi Arabia Ads completed...
Wow, in 27mins we all know exactly what need to happened when Hilux/Fortuner valve cover need some TLC. Thanks for sharing!
What about packing sealant in specific areas of valve cover?
I would give the area a thorough clean before undoing any fuel pipes, there's risk of intruducing contaminates into the injectors
Exactly, I was like 😧
Exactly what I needed to see. Thank you for sharing.
Thank you for sharing 👍
can you please show how to bleed the fuel lines?
Or the engine started even without bleeding?
Engine can start without bleeding
@@carfix1993 Thank you Sir
It was very helpful.
My fuel lines are extremely tight and I don’t want to strip them what’s the best way to get them undone
Use a proper fuel line wrench flare nut and they should t strip
I DIDN'T see the moment when you took off the top of the electrical injector from the cover, I can see you cut off the video in that moment. Why? Because it's really hard to remove.
It's very easy it just connector
Press and pull back
What was the reason for replacing the gasket and seals?
Was oil leaking??
Yes it was bad oil leak
my friend, what torque do you use to tighten the valve cover?
You already have the answer? Because i just broke my bolt nut inside. Now im fck up
I thinks its need specific torque because if too loose , it will still leak. If too tight the bolt broken.
Where did you get the injector seals from? Thanks.
Toyota dealer
What adaptor was used to tighten the nuts of the pipes
17 mm crowfoot wrench
How did you seal the half moon plug at the end of the camshaft
Hi friend, does this also fit the engine of a Land Cruiser 2012 3000 190 horse power draft?
Same engine model is the work the same?
This 1KD engine hilux
Do you have a spare part for the Land Cruiser 2012 1kd as well?
Thank you for this video. Very helpful.
Good job
After you did the job did you have any lights come on the dash
No any light
Thank you for your reply I have a 120 series if I do it it should OK then yeah
Yes you can do it
@@carfix1993 for the fuel line injector tight 22nm is this standard for other like Innova thank you new subscriber watching from Al Khafji Saudi Arabia Ads completed...
Yes it standard
Thanks mate 🍺
Im so disappointed in toyota for making a plastic valve cover.have to replace mine cause of cracking
Plastic ?? How come.? Its a type of silicone rubber man !
It's pewter and plastic. Mine cracked after replacing the gasket
Jeez ya musta put some tension on it 😂
Great job
great video
شكرا لك من مصر
Captain Bodg😅
No no no no es real cortaste ala hora de sacar la tapa de los inyectores y activaste cuando ya está desprendido así no juega Peru
ইনজেকটার খোলা লাগানো ভিডিও বাবান
et tu met pas de silicone dans les 2 coins et au plan de joint des carter ! tu es ouf !