DeWalt DWE7492 - adding extension table and installing a nice big drawer...
ฝัง
- เผยแพร่เมื่อ 5 ก.ย. 2024
- DeWalt DWE7492 - adding extension table and installing a nice big drawer... I continue expanding my table saw working station. In this video I share a very easy and effective way to build a small supporting construction on the outfeed side of the saw. I also install nice and space drawer just below. This element will require some minor adjustments as I am not 100 % happy with the result.
Enjoy!
Nice build! The outfeed extension looks superb. Cheers 👍😎🇦🇺
Endelig en video med mål👍
Really nice addition 👍 But , please buddy, be more careful with the table saw. I noticed a few critical mistakes against your safety. 🤜🤛
me as well, his fingers were to close to the blade when he was using the cross jig, should use a push stick.
And 2:56 with the push stick
Endelig en video med nogle mål 👍
Gold job!
Beware. I had the same type of digital level gauge (I think...), but I recently discovered it was really not very accurate Almost 0.7 degrees off when measuring normally, just using the bottom face, the magnetic one. Always good to double-check. One particular weird thing about it was that it also showed over 3 degrees different when rotating it 180 degrees while it was stuck magnetically to the blade. It also was 1 degree off when placed upside down, and showed nearly 1 degrees different if I measured on the opposite side of the blade (still referencing the bottom face).
Thank bro
Round over your edges on your out feed extension
Good job !!
Понравилось!
Nice job indeed, but where the upper parts of the extension supports hang, I have not seen your solution well.
nice video, what drawing tool are you using to create the drawing sketches shown in the video ?
👍
Parabéns!
Tem como disponibilizar o projeto?
Obrigado.
Buddy crosscutting without miter, buddy you are lucky no kick back happened, beside that I love the stand and extension I'll follow same once I get mine next month. I think you may need to extend t slot to extension if you need to use sled
He did use the miter gauge ...look again !!
@@adrianaosirish6065 Yes, he did use the mitre gauge, but the comment was about a sled. A sled is considarably bigger...
I like your table but I'm wondering, isn't it unstable on wheels ? Can you cut full size plywood on that thing ?
Thanks. I did not try it yet but it might be too small to handle such big sheets.
@@mmposhumer2535 I consider to make something similar, but definitely with brakes on the front wheels
Really smat design!May I have the outfeed extension sharp3D file?
muito fixe
ca manque de plan et de détail de montage !
👍