@@demoplcprog540 thank you..could you please provide me the required instructions for communication and read data from pm2120 because I have tried the program in your video but I can't read from the controller.
DTC you can add multiple sensor like even current or voltage as temperature sensor having more options like graph, control, alarm etc more details are in manul. Still if you need something you can ask me.
super bro. I done everything like you bro but { 6:53 } during online mode d1050 value not varied stayed in k306. i am varying temp also, can you guide me
I want to communication between Delta plc and ms1208 8 channel multispan temperature controller....how can I do that
i do this program exactly but the value of regester D1050 WAS 32277 , IS THIS TRUE I DO NOT CONNECT TEMP SENSOR , I SHORTED BETWEN TERMINAL 1,2 IN DTC
no its an garbage value.give right sensor type to DTC.
Bahi ek sw ziada temperature controller kay lie yahi ho gi
Programing
D1050
Secnd kiya ho ga d1051
Excellent
Can I connect PM2120 schneider power monitor with delta plc sx2 via RS485 modbus? thanks for your response
Yes off course.. no issue with that
@@demoplcprog540 thank you..could you please provide me the required instructions for communication and read data from pm2120 because I have tried the program in your video but I can't read from the controller.
Sir,pls tell me what is difference between DTC temperature Controller and 4 channel Thermocouple module or rtd module
DTC you can add multiple sensor like even current or voltage as temperature sensor having more options like graph, control, alarm etc more details are in manul. Still if you need something you can ask me.
hi, how i can get out put 0-20ma ? delta dtb4896cr model ? i want use it with vfd without plc
4-20 can be possible without any setting
What about if two controller with a plc for d1050, for 2nd controller d1051?
NO,2 controller device id is 1 and 2 address will be the same i.e.D1050 .you need drum sequence prog to move the value
super bro. I done everything like you bro but { 6:53 } during online mode d1050 value not varied stayed in k306. i am varying temp also, can you guide me
Please check drum Sequncer video maybe that will help you. If you are Communaiting with dop Or other hmi then it will be very easy to understand
@@demoplcprog540Thank you very much Bro.it is working very well, can you post video about how to programming two dtc1000r at a time with delta plc
It's temptaure controller. But I not getting output 4-20ma. Just all time on output 13.47v dc output.
Raheel S
ok I will check and revert to you
send your mail id
Please check what value it shows in 1012H and 1013H register
You can also set it
If it shows 100 and current is not 20mA then device must be faulty
sir how to wire and communicate 14ss and delta hmi and dtc 1000
For dtc and hmi direct 485 communication can be establish. And for hmi and plc use 232 communication.
Hi,
I wnt to Communicate 6 DTC what changes need in this program.
Addressing of dtc will be chenge viz k1,k2,k3,k4,k5.
But you also need drum sequncer otherwise your PLC show faulty value
More then temperature controller control