Home-built jackstands

Custom built stands I fabricated and welded for when I cut my frame on the caddy.

[@jeffalvich9434]

Those are very well built!!!! Much better than most any of the 3 ton jack stands commercially available!!!!! very nice job & very safe!!!!!!!!!!!!!! Just an FYI.... might also consider adding a bolt on larger base to them....typically you want about 3/4" base for each 1" of height.

[@victoryfirst2878]

I will be making these in a week or two. Nice work too.

[@theweldor757]

Good job brother ! I'm the same way . If you can built it yourself your way ahead a the game !

[@dodgesportsman772]

Holy crap!!! Those jacks could hold up a Building

[@leandrofrancaniteroi744]

Show de bola!

[@romeo_alpha0176]

Bad ass stands there. Would it be structurally compromised if there were holes drilled on the other side of the square tubing for finer height adjustment?

[@bmfspeedshop4562]

Yea I can't awnser that ... I mean I never fully trust any jack stands I prefer ramps, but I haven't made a set of them yet

[@aldencorbin3126]

a tip: watch movies at Flixzone. Been using them for watching lots of of movies recently.

[@novasilas9306]

@Alden Corbin yup, I've been using flixzone} for since november myself :)

[@kenzomarkus4888]

@Alden Corbin Yup, I have been using Flixzone} for months myself :D

[@charlescolby45]

@Alden Corbin yea, I've been watching on Flixzone} for since november myself :D

[@Sacrificepain66]

That’s right might as well make it yourself made in America

[@georgeowen2083]

They look good other than the fact you have a flat top and don’t have any V groove or edges to help prevent slide off.

[@bmfspeedshop4562]

Yea I was gonna run a bead on the edges but then I decided to leave it flat so they would all be the exact same height. I agree tho I did put some grinder cross hatch to make them better.