⛐ Check out our Garage to see what tools we use and recommend: www.amazon.com/shop/worldmechanics ⛐ Subscribe and hit the notification bell by the subscribe button for new videos: th-cam.com/users/AutoRepairGuys ⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
Thanks. Just replaced that pump on my 2011 328i coupe, E92. On mine, there were no pushpin clips. Basically 6 screws (8mm) and two nuts (10mm). Note: if ur washer tank is full, you will get washer fluid flood out when you pull out the pump. Note 2: the tank on mine is not as long as the one on his wagon. Note 3: I had a difficult time removing the horizontal tube from the old pump. Had to pry it a bit like he did. Note 5: I also changed the little filter that the pump sticks into.
Pressure loss on screen washer. Great video. Had to take out my Indicator to get mine out. Pressure was dropping when I had been trying to clear my windows. Pump was fine. Filter was clogged. Cleaned out the filter and the tank (old tooth brush on the filter and cleaned the tank out several times with boiling water and anti limescale cleaner). Saw on a few forums that this had been a recurring problem for some which led me to look at the filler hose. Ribbed hose seemed to be a magnet for gunge. Stripped it out easily enough (a couple of clips) and cleared it with a long radiator cleaner(big pipe cleaner that you can get from most DIY shops). It took several goes at either end to finally get the rinsing water to run clear. Popped an inspection camera down to check but you could do this with a torch and just straighten it out. This job took me over an hour as it was first attempt and didn't want to make a hash of it but I recon it'd take me about half that if I had to do it again.
great video, very well explained, had to replace on 2008 e90 today after washer stopped working (the wipers won't work either and no warning lights), no shortcuts available just have to take the wheel off and plastic guard only way to replace.
Good morning from Athens - Greece. I have a 2006 BMW E90 316i with 90,000 km very well maintained. Thank you for your viewing. I replaced the pump with a new one but it doesn't work - it doesn't throw water. What do you think the problem is? Thank you.
Follow up. I had some wheel liner missing, so it went a small amount faster. Pump screen was clogged with slime. Cleaned screen and flushed out tank. Replaced pump anyway.
Guten Morgen aus Athen - Griechenland. Ich habe einen sehr gepflegten BMW E90 316i von 2006 mit 90.000 km. Vielen Dank für Ihr Interesse. Ich habe die Pumpe durch eine neue ersetzt, aber sie funktioniert nicht - sie spritzt kein Wasser. Was ist Ihrer Meinung nach das Problem? Danke schön.
Hi there, I thought i dropped something in the reservoir however when i checked it nothing was there, i removed all the liquid and disconnected the plugs. Would that have damaged all the pumps?
Hoping you read this! My 2007 328i has a strange problem. The left rear door will lock during driving, but when I stop and lock all doors with key fob the left rear door unlocks! It has a new actuator.
Thanks guys, just replaced the failed pump on my E90 XI using this video. Mine did not have a leak so unfortunately, the reservoir emptied once I removed the hose. I can't seem to find the part number for the 3 pushpin clips. Appreciate any feedback if others can find it.
Stupidest design ever from BMW. On the e46 the windshield wiper pump was in the motor compartiment, accessibly by hand. 2 minutes of work and $11 for the pump.
My God how in the world this car maker BMW came to a huge prominence. I own 328i and after 5 years many many things are failing. Including this stupid little windshield water pump. What a freaking design by bmw one has to go through all this dismantling to reach to this little part. Folks I will never buy a bmw again. This is COMPLETE GARBAGE.
Thanks. Just replaced that pump on my 2011 328i coupe, E92. On mine, there were no pushpin clips. Basically 6 screws (8mm) and two nuts (10mm). Note: if ur washer tank is full, you will get washer fluid flood out when you pull out the pump. Note 2: the tank on mine is not as long as the one on his wagon. Note 3: I had a difficult time removing the horizontal tube from the old pump. Had to pry it a bit like he did. Note 5: I also changed the little filter that the pump sticks into.
![ILLSLICK - WINTER IS COMING [Official Video]](http://i.ytimg.com/vi/dwTMeM1zIhQ/mqdefault.jpg)
⛐ Check out our Garage to see what tools we use and recommend:
www.amazon.com/shop/worldmechanics
⛐ Subscribe and hit the notification bell by the subscribe button for new videos: th-cam.com/users/AutoRepairGuys
⛐ Our GoFundme Page: www.gofundme.com/auto-repair-guys
Auto Repair Guys hi, you said, you would link the clips, who needed to be pushed in. But I couldn‘t find them.
@@omot90 still hasn’t. 3 years later.
Thanks. Just replaced that pump on my 2011 328i coupe, E92.
On mine, there were no pushpin clips. Basically 6 screws (8mm) and two nuts (10mm).
Note: if ur washer tank is full, you will get washer fluid flood out when you pull out the pump.
Note 2: the tank on mine is not as long as the one on his wagon.
Note 3: I had a difficult time removing the horizontal tube from the old pump. Had to pry it a bit like he did.
Note 5: I also changed the little filter that the pump sticks into.
You said you would put a link for the fender well cover clips/ retainer pins. Where is it?
Thanks a lot! Finally found my answer that BMW touring has separate washer pumps for front/rear windows.
love your voice, and the way you say it at least twice, for novice DIY'ers like myself 😂😂 Thanks for shooting the video up close!
Pressure loss on screen washer. Great video.
Had to take out my Indicator to get mine out. Pressure was dropping when I had been trying to clear my windows. Pump was fine. Filter was clogged. Cleaned out the filter and the tank (old tooth brush on the filter and cleaned the tank out several times with boiling water and anti limescale cleaner). Saw on a few forums that this had been a recurring problem for some which led me to look at the filler hose. Ribbed hose seemed to be a magnet for gunge. Stripped it out easily enough (a couple of clips) and cleared it with a long radiator cleaner(big pipe cleaner that you can get from most DIY shops). It took several goes at either end to finally get the rinsing water to run clear. Popped an inspection camera down to check but you could do this with a torch and just straighten it out. This job took me over an hour as it was first attempt and didn't want to make a hash of it but I recon it'd take me about half that if I had to do it again.
I'll check that too, but after all them fasteners. Replacing a $10 pump seems a good idea. Thank for the heads up. Mine went the same way.
Mine was junked up too. Replaced pump anyway.
Thank you for a very clear video.! You are great at your job!
great video, very well explained, had to replace on 2008 e90 today after washer stopped working (the wipers won't work either and no warning lights), no shortcuts available just have to take the wheel off and plastic guard only way to replace.
7:51 pretty sure you just snapped the filter on the end of the pump so it's stuck in there
Good morning from Athens - Greece. I have a 2006 BMW E90 316i with 90,000 km very well maintained. Thank you for your viewing. I replaced the pump with a new one but it doesn't work - it doesn't throw water. What do you think the problem is? Thank you.
Unless I missed it you didn’t include the link for the clips
Thanks for the upload. Just saved myself a chunk of cash 😁👍
Thanks for this video. Just got an '08 e90 a few months ago and the washer went out.
Follow up. I had some wheel liner missing, so it went a small amount faster. Pump screen was clogged with slime. Cleaned screen and flushed out tank. Replaced pump anyway.
Guten Morgen aus Athen - Griechenland. Ich habe einen sehr gepflegten BMW E90 316i von 2006 mit 90.000 km. Vielen Dank für Ihr Interesse. Ich habe die Pumpe durch eine neue ersetzt, aber sie funktioniert nicht - sie spritzt kein Wasser. Was ist Ihrer Meinung nach das Problem? Danke schön.
Hi there, I thought i dropped something in the reservoir however when i checked it nothing was there, i removed all the liquid and disconnected the plugs. Would that have damaged all the pumps?
Turn the pump clockwise to get the pump out, don't just pull it upwards
Thanks for the vid - knocked this out in no time.
I love this guy!
Where did you purchase the clips from?
Can you add the link for the clip?
Hoping you read this! My 2007 328i has a strange problem. The left rear door will lock during driving, but when I stop and lock all doors with key fob the left rear door unlocks! It has a new actuator.
Sounds like you got a defective actuator. The same thing happened to me.
@@Red-Raider did bro just reply to his past self
hi mate..how to checks washer fluids level on my e90 320d 2011? washer fluids didn't came out after i pull the stick..
Thanks guys, just replaced the failed pump on my E90 XI using this video. Mine did not have a leak so unfortunately, the reservoir emptied once I removed the hose. I can't seem to find the part number for the 3 pushpin clips. Appreciate any feedback if others can find it.
Perfect video thanks 🙏 dude ...
Excellent video 👍
I like your channel because you put all information on where you buy the used materials like like
Gracias x el video muy bien grabado me sirvio mucho gracias de nuevo
Stupidest design ever from BMW. On the e46 the windshield wiper pump was in the motor compartiment, accessibly by hand. 2 minutes of work and $11 for the pump.
Otto Doktor I had a 1999 Nissan Altima and the pump was located in the same spot, I know is awkward
What size panel plastic clips
Thank you👍
Insane, getting mine replaced now by a mobile repair service covered by carvana.
Hello does anyone know if it is possible to remove it with the wheel on?
Well done.
Funny accent and even funnier voice....hilarious!
No link for the clips
www.ebay.co.uk/itm/BMW-3-SERIES-E46-E90-E91-E92-FRONT-WHEEL-ARCH-TRIM-CLIPS-INNER-LINER-SPLASHGUARD-/172735798564
Thank you, thank you!
Perfect
Is there anything on BMWs that don’t break after a few miles? Real money pits.
So far I disagree!!! My 2007 328i is a great car!
My God how in the world this car maker BMW came to a huge prominence. I own 328i and after 5 years many many things are failing. Including this stupid little windshield water pump. What a freaking design by bmw one has to go through all this dismantling to reach to this little part. Folks I will never buy a bmw again. This is COMPLETE GARBAGE.
excellent !
You forgot the 320si model 😅
Screw this car man 🤦🏽 pain in the ass to work on
👍👍👍
Just did it. What a fucking hassle
Thanks. Just replaced that pump on my 2011 328i coupe, E92.
On mine, there were no pushpin clips. Basically 6 screws (8mm) and two nuts (10mm).
Note: if ur washer tank is full, you will get washer fluid flood out when you pull out the pump.
Note 2: the tank on mine is not as long as the one on his wagon.
Note 3: I had a difficult time removing the horizontal tube from the old pump. Had to pry it a bit like he did.
Note 5: I also changed the little filter that the pump sticks into.