Mitsubishi Evo AYC Fluid Replacement & Bleeding with basic tools
ฝัง
- เผยแพร่เมื่อ 8 ก.ย. 2024
- How to replace & bleed AYC (active yaw control) Fluid on a Mitsubishi Lancer Evolution with basic tools.
How to bleed the AYC system using a computer:
• Tactrix OBD2 AYC Fluid...
Disclaimer:
This video was created for informational and educational purposes only. I cannot guarantee against the improper use or unauthorised modifications of this information. No liability for property damage or injury incurred as a result of any of the information contained in this video is assumed. Use this information at your own risk. I recommend safe practices when working on any vehicles and with tools seen or implied in this video. You are using the information and automotive parts shown in this video solely at your own risk. It is not intended to be a substitute for the professional advice of a service centre or mechanic.
![[Full Episode] MasterChef Junior Thailand มาสเตอร์เชฟ จูเนียร์ ประเทศไทย Season 3 Episode 13](http://i.ytimg.com/vi/NlY2uzrALY8/mqdefault.jpg)
Good show and informational video. This is definitely not beginner's stuff
Thanks for the comment.
Audio is horrible but the procedure is simple to follow
Yeap, this video was recorded a long time ago, so audio is not the best.
Brother, I just recently did drivetrain fluids at a rally garage on my evo 5. Now I have a horrible noise from rear when turning left or right while driving slow in first or 2nd. Noise comes when car is warmed after driving 10 minutes or so. Could this be a symptom of an unbled ayc system?? 😭
Have you tried bleeding the system? Also did you fill the correct fluid for the differential side and ayc side? Very important to not mix the two. Bleeding the system should solve the problem as long as the fluids are correct.
It's done. Sell it. Broken forever
So you can run ATF SP III ? Cause the dealer was telling me it was a different fluid plus only comes in a gallons a it’s 230 bucks
Yes you can run an ATF which specifically meets Mitsubishi SP III standards. I prefer to use Genuine Mitsubishi Diaqueen SPIII but if this is not available you can use any SPIII compliant ATF. I can't stress enough that it must meet that standard.
Millers millermatic for me