TL494 High Frequency Inverter & High Voltage SMPS (Switch Mode Power Supply) 1000 Watts

[@creativetoday3826]

I love you very much. I have been following you for a very short time, but I learned a lot from your videos because of the simulation you explain. Thank you very much.❤❤

[@ihtsarl9115]

It is Very Very important that you speak slowly and clearly so we understand otherwise you are wasting your time and the viewers time I could not understand any single English word although you are touching on very interesting subjects to me and to others I guess.

[@FROYOLOLOTM]

Quite good explanation mate 😊

[@electronic7979]

Excellent

[@nwaigbo3]

Thanks a lot for your wonderful lecture,
Please how can I filter the output to 50Hz

[@ExtralargeafricanEes]

How can I get the schematic diagram

[@yawarsaeed6499]

Thanks for sharing such an Awesome project. Can you please design and share the circuit board to operate inverter dc air-conditioner compressor to feed UVW windings with potentiometer to decrease or increase the running speed.
An early response will be highly appreciated.
Thanks & kind regards.

[@akbarjaghori1933]

very useful circuit but resistors wattages are not mentioned.

[@CUCARACHA707]

Frecuency operation of the circuit ??

[@Edmorbus]

Thanks for sharing

[@mohamedsub7023]

Thanks but for improving the design u need to add closed loop control for output voltage

[@malcolmwright7440]

Look again, i think the VoutDC from D1 to D4 connected to iN2; pin 16 TL494, via divider R12, R13 is closed loop control for output voltage !

[@mohamedsub7023]

Ah ok I see thank you

[@malcolmwright7440]

@G E T R E K T 905 Why tell me ? I am neither the designer or the publisher. You should send your suggestions to the originator, I have nothing to do with this other than pointing out the bleeding obvious to someones comments !

[@fareezmsd7269]

Hello MR..can you design for me..dcdc boost converter 12vdc to 300vdc in proteus

[@Marc-wb5jl]

Thanks. Justo buscaba esté diagrama, esque deseo hacer un mini soldador inverter muy simple haber si me funciona

[@ravikumarjanilot6079]

Please share pcb

[@bayramoglumurathan925]

Thanks.

[@katsuoto4684]

TL494 is very legacy controller. I think UC3825 is better than TL494 because it pulse by pulse current limmit function that protect MOSFET from over current complately.