I adjusted the 4mm and 12mm to the middle as you suggested, and the results were impressive. Thankfully I didn’t even need to mess with the other two adjusters, as it was probably pre-set well
just make sure its tight enough that the spring does not move. you shouldn't need to add preload at all. you should be able to loosen it with your hands
I adjusted the 4mm and 12mm to the middle as you suggested, and the results were impressive. Thankfully I didn’t even need to mess with the other two adjusters, as it was probably pre-set well
Nice!
Great. I'll test tomorrow 👍
Awesome. I was looking forward to this one.
Hope you do this for kke springs and kke forks on a stock 2024 Surron lbx
Thank you for that. Please comment on the proper SAG for the Arma!!!!
We’ve always just tightened it down enough so the spring doesn’t move. just hand tight
Need this same thing for the Ferro Forks
Its been filmed and will be posted very soon!
@@TBElectric Cool thanks
Good stuff! Just installed it - what’s the right pre-load for the spring? Best tool to use to tighten the collar?
just make sure its tight enough that the spring does not move. you shouldn't need to add preload at all. you should be able to loosen it with your hands
2nd