Man bro i had the same mission on my truck i did alot of work until finally found the issue it was a fuel temperature sensor it had a rough idle, really bad cold strt, and check engine light. After changing that fuel temperature sensor now my truck runs like a champ
I'm having mine with the same problem normally it's going from the 1st to 2nd gear and then stopping at red lights. I have changed the fuel filter I've done all the spark plugs everything connected to those Do you have any suggestions of why she wants to choke out When I'm out of red light I can give her a little bit of gas I kind of calm it down then sometimes it starts backup again
Thanks for watching. Wonky idle could because by a number of things. Mass air flow sensor, O2 sensors, throttle position sensor, idle air control valve, vacum leaks to name a few. I would suggest try cleaning's the throttle body first.
Ive got misfire once per second....at 2000 rpm........ As well as a really rough idle the fuel injectors were replaced as a set a couple of years ago All I can think of is cam shaft damage.....
22mm socket on the crankshaft bolt? My 1994 D21 takes a 27mm socket. What year were you working on? And be sure to turn the bolt CLOCKWISE to move the Shaft, people. Counter clockwise will unscrew the bolt! Noooo.
Thanks for the tip and thanks for watching. Mine’s a 96 but I’m like the 1 millionth owner. Who know what the previous owners did.but yes mine was 22mm.
1996! I also have a '96 hiding in my garage. I'll go check it now and come back. (later) my 1996 has a 27mm crankshaft pulley bolt. I'm the second owner.
I got the same problem but it’s in 3rd&4th gear when wot but it works fine if I baby the throttle only in 3&4 when I go in 5 and just cruising for a bit the check engine light come on for ignition signal drop a gear light goes off but still not difference change spark plug ,the wires , and coil and air ,fuel filter any ideas
Thank for watching. There are many reasons why your truck is stalling. Let’s start with the basics. 1. Check for vacuum leaks. 2. Check the fuel pressure. 3.If you haven’t done it lately, I’d give it a tune up. ( plug, wires, distro cap,etc)
1 st gen frontiers had the KA24 engine 98 to 2000 after that they came with a 2.5 same as 3rd gen Altimas stay away from that Renault's garbage 1st and 2nd gen Altimas last great Nissan cars
@@zacariasblanco9738 the frontiers I looked at had the v6s that has milk shake oil they where 98-04 that I looked at I'm looking to buy a 2005-2015 with the 4.0 now what do u think about that engine?
Man bro i had the same mission on my truck i did alot of work until finally found the issue it was a fuel temperature sensor it had a rough idle, really bad cold strt, and check engine light. After changing that fuel temperature sensor now my truck runs like a champ
Thanks for the tip and thanks for watching.
I'm having mine with the same problem normally it's going from the 1st to 2nd gear and then stopping at red lights. I have changed the fuel filter I've done all the spark plugs everything connected to those
Do you have any suggestions of why she wants to choke out
When I'm out of red light I can give her a little bit of gas I kind of calm it down then sometimes it starts backup again
Thanks for watching. Wonky idle could because by a number of things. Mass air flow sensor, O2 sensors, throttle position sensor, idle air control valve, vacum leaks to name a few. I would suggest try cleaning's the throttle body first.
@@NickG All sensors have been clean too
Clean out your egr valve
Ive got misfire once per second....at 2000 rpm........ As well as a really rough idle the fuel injectors were replaced as a set a couple of years ago All I can think of is cam shaft damage.....
Thanks for watching. If your chasing a misfire start simple. Replace plugs and wires one at time.
22mm socket on the crankshaft bolt? My 1994 D21 takes a 27mm socket. What year were you working on? And be sure to turn the bolt CLOCKWISE to move the Shaft, people. Counter clockwise will unscrew the bolt! Noooo.
Thanks for the tip and thanks for watching. Mine’s a 96 but I’m like the 1 millionth owner. Who know what the previous owners did.but yes mine was 22mm.
1996! I also have a '96 hiding in my garage. I'll go check it now and come back. (later) my 1996 has a 27mm crankshaft pulley bolt. I'm the second owner.
Nice job Nick.What plugs did you go with?
I used a NGk. wich was what the factory used.
I got the same problem but it’s in 3rd&4th gear when wot but it works fine if I baby the throttle only in 3&4 when I go in 5 and just cruising for a bit the check engine light come on for ignition signal drop a gear light goes off but still not difference change spark plug ,the wires , and coil and air ,fuel filter any ideas
Try the fuel temperature sensor it work for me now my truck runs awesome and nomore lights on my dash
Nice job and Ya know what the best part is if you really F_ _kup You can always call on your older brother Fuzz. Cuz we all know he can fix anything.
My 94 Nissan turns on but turns off I need help
Thank for watching. There are many reasons why your truck is stalling. Let’s start with the basics.
1. Check for vacuum leaks.
2. Check the fuel pressure.
3.If you haven’t done it lately, I’d give it a tune up. ( plug, wires, distro cap,etc)
@@NickG I saw pressure air coming out from the spark plug or the muffler the last spark plug what does that mean
I hate to be the guy that says it. But it might be time to take it to a shop.
Wanna sale it? I need parts
your throttle position sensor may need adjusting also
I looked at 5 Nissan Frontiers to buy an they all had milkshake on the oil cap typical Nissan I guess
Yea, the head gasket is the weak link in these things, but they can be fixed.
1 st gen frontiers had the KA24 engine 98 to 2000 after that they came with a 2.5 same as 3rd gen Altimas stay away from that Renault's garbage 1st and 2nd gen Altimas last great Nissan cars
@@zacariasblanco9738 the frontiers I looked at had the v6s that has milk shake oil they where 98-04 that I looked at I'm looking to buy a 2005-2015 with the 4.0 now what do u think about that engine?
@@kamryn7496 i heard is not as bad as the 4 banger
@@kamryn7496 my friend had a 06 pathfinder with that engine and it was reliable
Just use boot from old spark plug wire
@@tracbradley3711 thanks for the tip and thanks for watching
😝🍻