This enter then type the size trick, I did not know and was looking for so badly! Thank you very very much saved my time and energy! so well explained!
Good question. Click to start drawing a normal wall, then hold 'Ctrl' while making the next click. This will make a semi- circle wall, that can be clicked on and adjusted further.
How do you use it to draw simple basic 2D elevations? I tried and the programs screws up when you try to draw roof angles. Do you have a link for that?
This enter then type the size trick, I did not know and was looking for so badly! Thank you very very much saved my time and energy! so well explained!
THANK YOU. Great tutoring! you saved me TONS of money.
How can you create dimensions in a practical way, beginning from the inside or the outside of the wall, not from the center.
i was hoping in drawing some airvents and piping and draw where they go, is there a way to do that
Woow Enjoyed All Videos, thankyou How Do i drow a Round Room
Good question. Click to start drawing a normal wall, then hold 'Ctrl' while making the next click. This will make a semi- circle wall, that can be clicked on and adjusted further.
Is it possible to create stairs that go down to the ground floor?
Having problem in cutting out the slab for spiral staircase can you help
How do you use it to draw simple basic 2D elevations? I tried and the programs screws up when you try to draw roof angles. Do you have a link for that?
This video is great unfortunately I am in need change the dimension scale to inches to 1/4" example I need to dimension like: 12' - 1/4"
Is there a way to make the print out's fuller and fill the page rather than a small size draft?
There are some options under File > Page Setup . I've also used 3D View > Create Photo. Hope that helps!
Where to insert columns 🤔🤔