I just bought a Clark yesterday today I went to start it it started an ran I take it fork lifts are cold blooded? But I noticed some oil was shot out exhaust I guess it's oil ? I turned it few times then I held pedal wide open an it started
I have a Hyster H40H i thinks its a early 80's model. Well when I start it up and give it gas Monotrol pedal all the way down I have to hold it there for 5 to 10 mins then it will slowly start inching forward. Acts the same going in reverse. Any ideas? Read something about a inching valve. The lift hydraulics work fine. Also if any has a pdf manual that would be cool too.
Don't work on a lot of crowns, but there are things to like about crown and there are things to like about other brands as well. I personally like raymond reach due to the ease of working on them. But then again that just maybe because I work on them a lot.
I just bought a Clark yesterday today I went to start it it started an ran I take it fork lifts are cold blooded? But I noticed some oil was shot out exhaust I guess it's oil ? I turned it few times then I held pedal wide open an it started
it's the same trans-axo oil as the torque converter? On this model
Is this an interference engine or non interference engine? I have the same model engine with suspected broken timing chain.
I have a Hyster H40H i thinks its a early 80's model. Well when I start it up and give it gas Monotrol pedal all the way down I have to hold it there for 5 to 10 mins then it will slowly start inching forward. Acts the same going in reverse. Any ideas? Read something about a inching valve. The lift hydraulics work fine.
Also if any has a pdf manual that would be cool too.
Hey Justin, I would definitely check pressures in the valve assembly. give me your email so I could send you a manual.
What is the best brand of forklift to buy?
It depends on what you need. In my opinion for reach trucks I would go for raymond for ICE trucks I would go for toyota.
Raymond a/c for indoor use
@forkliftgeek what about crown?
Don't work on a lot of crowns, but there are things to like about crown and there are things to like about other brands as well. I personally like raymond reach due to the ease of working on them. But then again that just maybe because I work on them a lot.
Is this test light a regular test light that we use for testing a fuses or is it a special test light made for spark test ?
This is just a regular 12 volt test light. but you cannot use the LED type test light, the high voltage would burn out the LED.
Change or rebuild l/p regulator...impco cobra
Who made this engine?
Peugeot
Thx!
@@forkliftgeek10 could you tell me model ?
I think it's an XN1P