Shaper restore part 8 - Recreate ratchet gear part 3 for Ai Hembrug shaper

In this episode. I shot for making a gear. On camera. But the HAY FEVER stops everything

[@Rustinox]

The little Hembrug doesn't like slotting. That's a bit of a problem.

[@DoMetalStuff]

Hey Michael, that's right. which I found out in my previous attempts. is that the clutch came loose. when everything was tight again. it went well. cut about a tenth deep. sounded the best. it went fine until the sneeze. but luckily I have 1 gear where I can continue for the time being