INSTALLING COROLLA GAUGE WITH TACHOMETER! | AE92/EE90 Toyota Corolla
ฝัง
- เผยแพร่เมื่อ 10 พ.ย. 2020
- PALIT GAUGE SA GAUGE NA MERONG TACHOMETER ( RPM GAUGE)
XL GAUGE TO GL GAUGE FOR MY COROLLA!
-------------------------------------
Music by HoobeZa
Link - • [No Copyright] Chill L...
------------------------------------- - ยานยนต์และพาหนะ
Bossing plug n play lang ang panel gauge ng big body XE sa XL para magka rpm XL. Salamat po sa sagot
If your temp gauge jumps and stays on H after the swap, this might help you, because it worked for me. My problem was: ign off, plugging in the middle connetor pegged the temp on max.
Cut the brown (gnd, unused on old cluster) and yel/grn wire (bulbs gnd and temp sensor signal ground, goes to a single connector at the thermostat housing) about 5cm away from the connetor, twist and SOLDER together the wires, connecting the brown into the yel/grn wire.
What happened was that the signal gnd of the temp gauge was direct gnd, pegging the gauge on max.
Otherwise, original distributor and the tach should work fine. Check the bulbs while the cluster is off. Turn signals are wired through the hazard lights switch, so dont drive with it disconneted if you wanna test stuff.
My old clust has 3 plugs at the back,and my new one has 4. Is there a diagram to rewire please.
@@ultrainstinct1181 sorry, i have no diagrams.. couldnt find them for my car either. Seems strange that the number of connectors is different, are you sure it fits your car?
@@pistamessi yeah,it does it's from the denso 2e to the denso 2 160i with Speedo.
I just found this and I have this problem. Could you clarify if I need to solder the two wires in the connector side? Brown from connector to yellow from the cable tail?
@@yomurita oh man, its been a while since i did this, but basically as far as i remember, i cut the brown (i believe the one next to the yellow-green) and soldered the brown from the connector to the yellow-green in the loom. Just took the isolation off the y-g and wrapped the brown around and soldered it. I believe the y-g is the wire that goes to the temp sensor so you have to connect the brown from the connector to it. To figure this out I followed the conductive trails from the clusters and compared them, so you can check it for yourself. Hope I helped with this. Tell me if it worked :)
Boss ask lang po if ever po ba naka long gauge ung ae92 tapos balik ko ulit ung stock na gauge ko pwede pa po ba ?
My Vehicle Corolla 96 have no techometer (RPM meter) in Dashboard and have only speedometer.
Please tell me proper Solution to installed both are speedometer and RPM meter in same time in My vehicle dashboard.
Boss san nakakabili ng gauge cluster na ganyan ung may tachometer
Hi, I need help with the Rev meter I swap a Toyota Tazz 2e cluster with a Toyota Tazz cluster 160i, the Rev meter doesn't work how do I connect cables to make it work?
I'll give you the link regarding on how to check the rpm wire to manually link it th-cam.com/video/lAVg9W2p6Ns/w-d-xo.html
how did you wire it up ? , my 160i cluster doesnt want the rev to work , i also had a 2e cluster , and now i put a rev 160i cluster but it doesnt want to work, please help me
you need to locate the rpm wire and manual input it. maybe you don't have the original distributor that's why it's not automatically wired
Morning
I want to fit 1.6i cluster on my 2e 1.3 conquest will it work without rewiring?
Hi man, I've been wondering the same thing. I've already bought the dash. I have no idea if you're still interested, but I'll let you know how it goes.
boss tanong ko lang kung san po ba ang pin ng RPM and temperature gauge? para makita ko ang wire kasi pag nag hazard ako gumagala temperature gauge sabay ng click. paano po ayusin.?
Hi, regarding temp gauge, you just add a ground connection to the (-) point of the gauge and it will be fully functional.
About to do this is my AE95, did you swap the odometer over aswell, or just the whole cluster.
I did swap it completely, I didnt bother to change my old odometer bec I am scared that it might not work If I change it to my old. Just swap it plug and play!
@@jayeconstantino Yeah true, in my country we have to show accurate odometer reading, hopefully i can swap without any troubles.
@@knibusu2249 let me know how did it went after you do it! :D
Hi, congrats good job!
Did it to my EE90 and wonder that you missed a ground wire to make temp gauge functional.
actually I didnt miss a wire for the temp. the temp works fine at around 7:06 you'll see that the temp is in the middle like in normal state of temp :D
@@jayeconstantino Interesting! Temp didnt work for me and when checked negative ground is missing, perhaps a problem on the printed circuit.
Point is such replacement works great and is very exciting to drive having tach on the dash.
Regards from Cuba!
@@jorgeborroto5822 yes very true it's good having a tach. thanks man!
hi guys. i also have same ee90 panel gauge. I did diy change of panel gauge to led lights last week. now I have a problem on my gas and temp gauges. The gas gauge now goes to full as soon as I turn the key while my temp gauge no longer triggers the automatic switch on of my rad fan once temp gauge reaches the middle. It just continues to rise to overheat even if I already switched on the aircon with both rad and aux fans running. I believe this is not the correct reading since this only happened after I changed the gauge lights to led. I did not do anything else but change the led bulbs since I don’t know anything about electricals. Can you guys pls help me coz I can no longer drive my corolla sb since I’m afraid that I might overheat on the road although I know that the temp reading is not accurate. Thanks.
@@josephreyes9778 try to visit an electric shop near you bro! baka wiring problem lang or sensor ganun. hehe wala din me deep knowledge sa electrical e.
Hey, I want to do that also, did you have to connect some other wires for rpm or no? or do you just plug your old cables what you had
it's plug and play if you have the original distributor of your car. but if the rpm didnt work then it means it's not the original distributor. but usually it's plug and play! thanks for visiting my channel man!
@@jayeconstantino great! distributor is original, only what i did on my car is solex 40 addhe carbs upgrade and I want to have rpm gauge, and car have only 75K km only
@@manojlo5946 wow that's so fresh! ^^
@@jayeconstantino Where did you buy laps for tachometer?
@@manojlo5946 what do you mean laps?
Ano po pla sukat ng ilaw po? ee90/2e po yung gauge sakin same lng po ba yan ng AE92?
yes po t10 led nilagay ko hehe
Wiring diagram please. My old cluster has 3 pins in the back the new one has 4
not quite sure about the diagram bec when I had it installed it has the same diagram maybe you have different model or it's not really plug and play try searching out "ae92 gauge berdie" he tried checking the diagram bec he didnt have the original distributor
Boss ask ko lang need po ba i full tank para mag accurate ang fuel gauge? Saken po kasi nung nakuha nasa gitna pero konte na yung laman bago ko palitan so nung nag pagas ako ng 300 umangat pa siya. Need po ba i full tank ? Salanat po sa sagot
actually natutunan ko kay brother breds and ez works garage kay doc chris na mas maganda full tank siya agad tapos if bumaba below half full tank na ulet hindi siya sayang mas maganda daw yun sa life ng makina and ng sasakyan mismo lately bro di ko lang vinideohan kase may mga ineedit at asikaso ako pero nangyari saken below half siya may isang guhit pa pero di na siya mag start upon checking gas lang problema di na umangat kaya ang ginagawa ko lagi kapag half na full tank na agad para monitor mo din kung ayos yung fuel gauge mo :) pero sa mga groups if ever palyado yan sa mga groups naten dito merong mga nag rerepair nyan! good day ka corolla!
@@jayeconstantino Maraming salamat boss. :D
Can you send me the link for the lights please
Hi. Ask ko lang sana if saan mo nabili ung rpm gauge? Thank you.
kay Jay Zam paps. madami nagbebenta online tingin tingin kalang :)
Paps ee90 unit ko nag dpa electronic type ign plug n play parn kaya?
di ko sure bro pwede mo naman try if ever di gumana yung rpm ibigsabihin di orig yung distributor if ever gumana edi goods haha
Paps may binigo or dinagdag sa linya ng wire?
wala paps kapag orig yung distributor plug and play pero kapag hindi na original distri watch mo dito yung babanggitin ni paps berdie th-cam.com/video/lAVg9W2p6Ns/w-d-xo.html
Sir san ka nakabili ng panel gauge niyo? Yung sa car kasi namin di din gumagana, gusto sana namin palitan
sa marketplace po madami mam. check AE92.ph group or yung group ng friend ko which is Toyota Smallbody&Parts JDM/PHDM at iba pa(SeeJeem)
check nyo lang madami nag bebenta nyan mam!
@@jayeconstantino okay po sir, salamat po,
Hey man congrats, where did you find the gauge? I have 92 corolla and I need one of them too. Can you send me the link or can you help me to find the same?
where are you from brother? this is from the fb marketplace here in the Philippines.
@@jayeconstantino I am living in Turkey, if the cost is not too high, I can buy it. 1 US dollar is 8 Turkish Lira. Also I need shipping of course. 🥺
@@FatihCanVaral not sire how much shipping is there no corollas being part out in your area like surplus shop for parts?
@@jayeconstantino there are some shops but they want really high prices. If you have any link, I would like to discuss with seller.
Idol paano mo nagagawa yung 500 rpm lang
na totono yun malapit sa may carb hehe pa tono mo sa mekaniko mo then sunod nun ikaw na naglalaro ng rpm pero di okay yung 500 rpm lang ha stable rpm na ginawa ko is 800-900
Anybody have problem with the full indicator?? Mines doesnt work well, i have full tank but the indicator say me i have little bit less of 3/4
I do have the same issue that's why I always do full tank every after using :D
@@jayeconstantino and do you know, how i can fix that?
sadly I don't@@luislovell2000
paps anu kaya size ng mga bulb
t10 bro saka t4 ata yung isa
san ka naka bili ng may kasamang tachometer kasi puro pang right hand drive nakikita ko
meron sa marketplace brother
@@jayeconstantino hirap humanap dito sa america ng may kasamang tachometer puro oem replacement lang
@@jojoordoveza6539 pasuyo sa uuwi na kamaganak hahaha mahal yan sa america for sure since onti lang pala puro oem replacement meron.
Paps pwede pa blog din po kung paano magkalas nian gauge panel po?
Upload po ako tomorrow ng mga pano kalasin paps may mga screw lang yan sa paligid then pagdating sa gauge is may reference galing kay sir berdie naman na corolla owner din kakatuwa dito sa youtube tulungan mga naka corolla may mga new things din akong natutunan from sir berdie and sir breds ❤️ mabuhay tayong mga naka corolla
actually nandyan pala sa video ko yung mga pwesto ng turnilyuhan na aalisin mo :D
@@jayeconstantino abangan ko bukas paps papasubscribe na rin kita sa mga kaibigan ko po 😊 TIA po😇
@@dodengdaga4138 nandyan paps andyan mga turnilyo na kailangan mo alisin watch mo hehe
new subscriber nio po paps tinag ka po.pla sakin paps BREDS 😊
a tip: watch movies on Kaldrostream. I've been using them for watching loads of movies recently.
@Keagan Duncan yea, been watching on kaldroStream for since november myself :D
@Keagan Duncan Definitely, been using kaldrostream for years myself :D