Nice. tanong lng po. Meron po kami na LG 55in tv, kaya pa po ba marepair ang lcd panel na may open/shorted circuit? bali ni-repair po ng technician at ginawa ay ung tape method.. pero kaya pa po ba tlga magawa ung pinaka sira nun na circuit?
Hi it's mostly guess work and experience i guess for the capacitor value. You can measure those in the other rails i guess and try. Or sometimes you lucky and find the circuit diagram. Yep unfortunately lots of guess 😂
I think he just left out the capacitor. The capacitor is there to reduce any noise on the power from affecting the signal. Any capacitor value of the same order of magnitude should suffice if you find you need the filtering.
Sir very informative video, I have vertical line's for first 4 minutes and slowly freezing picture with audio starts then in another minute clear picture with proper audio comes from LG-47LA6200 TV (3D model). I kindly advise, all voltages are okay from T-Con board.
Hi, at 5:25, not really sure of their name, but there are golden tapes with traces soldered at the top of the board, one of them on my tv got detached, is it possible to solder it again on the board?
Hello, how are you? I brought an LG 37lg606 ur LCD TV for repair. The inverter board had a problem and the TV only stays on standby. A fuse and MOSFET number 8447 were burned on the inverter board. I replaced it and replaced the MOSFET with 45n03. Now the TV turns on. The image fills the problem. Is there a replacement for MOSFET or not? Thank you for your guidance. 🙏🙏🙏🙏
@@tevzTVTevatronics Yes, the picture is perfect, when I use MOSFET 45n03, the picture fills up and today I used another MOSFET 50n06 and the picture came, but the picture gets dark in the middle, it doesn't fill up anymore.
My samsung 32" led tv backlight turns on and off when the power supply or card is touching the metal of the led. But when i lift both boards then the backlight turns on. And there are colored vertical lines on whole screen.
Hello, considering the connection of many parts, how did you determine that this capacitor has a connection? And why didn't you assemble that capacitor
Thus capacitors are connected in parallel so they like all are shorted. do you mean to desolder the capacitor? I desolder the lowest ohm reading and that the suspected shorted capacitor.
@@tevzTVTevatronics Thank you for your response So, we take the ohmic capacitors in places where the ohms are much lower than in other places, if we have them, is the part suspected to be connected
This video teach me how to get short pf very easily way. Superb work
Superb job sir🙏
Good job great job
thanks kaTech.. big help to improve troubleshooting...God bless new to your channel.... pashout out katech...
Good information sir 🌹
Very good job
Thanks sir for sharing your ideas👍
well don sir
Nice tutorial sir for repairing television thank you for sharing this video
Thanks for watching
Thank you Sir,you are the best teacher.😊
Hello idol magandang buhay thanks for sharing this
thanks again for sharing sir god bless🙏
Keep up the outstanding work tevz 📺👏👏👏👏
Saludos, excelente video
Good job like always ⭐⭐⭐⭐⭐
Thanks again!
Excelente 👌
🤗😊love this work
Thank you! 😊
Same to
nice job
great master
Good job....thanks 👍
Show amigo Bela dica
Hai it's fantastic fuilt 👌👌👌👌👍👍👍👍
sir exelint information good works
Keep watching
I like your video!!!!
thanks you so much sir another tip to isolate the shorted line
Good job papa ❤️
Thanks you very much really l like your nice video.
You are most welcome
Thanks very much I have learn so much from your video God bless you sir
You are very welcome
Simply magic
Good work boss
Nice video 🙏🙏
Many many thanks
Good job thank you
Thank you to
Hai watchung ur channel from india
Greet
Excellent super bro thanks
Welcome
Saya suka cara kerjanya ...cepat dan akurat...
❤
Thank you friend.
Thank you too
Sir, My congratulations 👍🙏.
Many many thanks
Expert na sa trabaho
Good boy
Thank you
Nice video
Thanks
Thank you sir
good job repairing that kind of trouble shoot
thanks
good
Great video thanks very much for all you show here in your chanel , is very much apreciated.
My pleasure
👍👍
Thanks for exposing
No problem
Good Good
Thanks
👍
Thanks sir please give one video for best tresing method for finding short component in any motherboard for 1.8,3.3,and 5 volt shortnig
Отличная работа! Спасибо за интересное видео.
P.S. За кадром петушки кукарекают 😊👍 Круто!
Thanks
Welcome
grazie
thanks
Welcome
seguimos aprendiendo.
Thanks for sharing sir.
What is the reason why you chose to use your analog voltmeter when checking voltages?
I also use digital, I use analog on this video because its easier to see if the voltages fluctuate. See the needle moving up and down.
@@tevzTVTevatronics thanks for explaining sir. I learned something new again.
Hii tevs. I'm a big fan of your videos. Please make a video on how to modify led TV power factor correction. All led TVs from 42 inches
Will try
Hello, i just want to ask
How we get the same value capasitor that you have changed?
Is possible if we install a random value one?
❤️💕❤️👍💕❤️❤️💕❤️🧚
was that a T-Con board ?
I have a Panasonic 50 inch. TC-P50G25 plasma 2010 model and 4 blinks any suggestions to fix! Thanks
New subs her sir
Thanks for subbing
W
with what value you replaced that capacitor please ?
Great job btw
2.2 microfarad upto 47 microfarad will work.
@@tevzTVTevatronics thx a lot man
what is value of C57 capacitor was replaced? Farad? Voltage? Thanks
Your videos good but music is very distabance
Another Philip model K320wd8 same to your troubleshooting issue standby mode and no video.
i am electronics tic in ksa
Nice. tanong lng po. Meron po kami na LG 55in tv, kaya pa po ba marepair ang lcd panel na may open/shorted circuit? bali ni-repair po ng technician at ginawa ay ung tape method.. pero kaya pa po ba tlga magawa ung pinaka sira nun na circuit?
Hi sir, when checking shorted capacitor, tv must be plugged in or should be off ?
And multimeter should be on DC mode or continuecy mode please
It must be unplugged. resistance continuity mode with a buzzer.
Good evening, very good video, I saw that you changed the capacitor, how did you know its capacity, so that we can learn too.
When it comes to shorting you first check the capacitors, they are prone to shorting
Hi it's mostly guess work and experience i guess for the capacitor value. You can measure those in the other rails i guess and try. Or sometimes you lucky and find the circuit diagram. Yep unfortunately lots of guess 😂
I think he just left out the capacitor. The capacitor is there to reduce any noise on the power from affecting the signal. Any capacitor value of the same order of magnitude should suffice if you find you need the filtering.
San mo nakuha announcer mo🤣🤣😂 lufet
windows narator
Sir very informative video, I have vertical line's for first 4 minutes and slowly freezing picture with audio starts then in another minute clear picture with proper audio comes from LG-47LA6200 TV (3D model). I kindly advise, all voltages are okay from T-Con board.
Reflow the MCU the big IC
@@tevzTVTevatronics Thanks Sir, will check and reply back
Hi, at 5:25, not really sure of their name, but there are golden tapes with traces soldered at the top of the board, one of them on my tv got detached, is it possible to solder it again on the board?
Yes it can be solder back.
Sar how to capacitor value calculate please video
😄😄😄😄😄😄
i change the ac convertor 5 capacittors and the line draiver , the scren function vhen the logo samsung start then the scren bluring.
Good boy translate to Sinhala
Sony 55x7007E after 30minutes On and Off amd the other one with the same model no video , the backlight will tun On and then Off after blinking 6x
Why you use analog multimeter
I have monitor TV P2250 turn on for 1 second and off again
What you thing is the problem in your experience?
its the backlight or the panel that may have the problem.
Hello, how are you? I brought an LG 37lg606 ur LCD TV for repair. The inverter board had a problem and the TV only stays on standby. A fuse and MOSFET number 8447 were burned on the inverter board. I replaced it and replaced the MOSFET with 45n03. Now the TV turns on. The image fills the problem. Is there a replacement for MOSFET or not? Thank you for your guidance. 🙏🙏🙏🙏
I'm good thanks. Is the backlight turned on now?
@@tevzTVTevatronics Yes, the picture is perfect, when I use MOSFET 45n03, the picture fills up and today I used another MOSFET 50n06 and the picture came, but the picture gets dark in the middle, it doesn't fill up anymore.
@@tevzTVTevatronics If possible, give me your Instagram ID or WhatsApp number so that I can send you the video
so that problem part wasnt even needed in long run?
Hi Tevz, how to know the value of the faulty capacitor, unless you have its circuit diagram?
The neighbor capacitors usualy have similar values
@@tevzTVTevatronics Thanks.
Newbie is watching
pls sir..this panal VAA prasent Q1 smd transister nomber...? ...or data..? thanks...
7:58 was that a beer crack sound at 8:00 min
Madali tingnan piro kami na gumawa. Napaka hirap talaga
Brother you from which country ?
Philipines
Thanks
We
My samsung 32" led tv backlight turns on and off when the power supply or card is touching the metal of the led. But when i lift both boards then the backlight turns on. And there are colored vertical lines on whole screen.
The panel have hair lines.
Practically impossible to have 0.5 Ohm as tracing line resistance !!
Hello, considering the connection of many parts, how did you determine that this capacitor has a connection?
And why didn't you assemble that capacitor
Thus capacitors are connected in parallel so they like all are shorted. do you mean to desolder the capacitor? I desolder the lowest ohm reading and that the suspected shorted capacitor.
@@tevzTVTevatronics Thank you for your response
So, we take the ohmic capacitors in places where the ohms are much lower than in other places, if we have them, is the part suspected to be connected
@@tevzTVTevatronics What I mean is that after diagnosing the defective capacitor, you did not assemble the new capacitor in its plac
@@protection4541 its was th-cam.com/video/Cvvv42mGp2M/w-d-xo.html
Pano po mlaman ang same value ng smd caps na ipapalit sir
Pwede 2,2 uf to 47 uf.
Sir tel me your country name
Philippines
Your AI voice over sounds depressed you should give it some electrolytes😆
🤣🤣🤣🤣
what happened with your chicken 🐓🐔🐥, they are affraid with ur capacitors explotion 💥🔥
Pls not mix any music in your videos
Some enjoying the music.
ano fb account mo master
Teva electronics
Very good job
Thank you! Cheers!