How many cells does your battery have? And did you check the voltage with a multimeter? It was giving the warning because the connected battery voltage was below 11.1 If you had a 2S battery I would set the alarm voltage to 7.4 volts. Some pilots do take their battery voltage down lower than 3.7 per cell but I would not recommend that.
![Гайд для начинающих: как настроить аппаратуру на EdgeTx [Radiomaster Boxer ELRS]](http://i.ytimg.com/vi/wU67j2G5Ibg/mqdefault.jpg)
Thanks for the tip. Great idea of applying a delay before the warning - I will program the same in my TX16S. Have a nice weekend!
Thanks, you too!
That works. But does anyone know how to get chosen Telemetry sensors displayed on any one of the "flying" pages?
The telemetry sensors only on the Telemetry screens.
why my rxbt not showing the voltage? how to fix it?
Have you discovered New sensors in the Model Settings, Telemetry?
@the-happy-RC-flyer Yes, all telemetry sensors have values, except rxbat not showing the voltase, there is only a line
What receiver are you using and does it have a voltage sensor wire?
i did this and set the voltage to 11.1 the voice just say critical low battery even with a fully charge battery...
How many cells does your battery have? And did you check the voltage with a multimeter? It was giving the warning because the connected battery voltage was below 11.1 If you had a 2S battery I would set the alarm voltage to 7.4 volts. Some pilots do take their battery voltage down lower than 3.7 per cell but I would not recommend that.
@@the-happy-RC-flyer its a 3 cells brand new packs, freshly charge 4.20v each cells, i did check each cells with a multimer.
@@dji_mharyhu Then you need to take a look at the sensor details and calibrate the sensor to display the same voltage as shown on the multimeter.
Please help me my radio master boxer is not working the screen just blink
Hi, remove the batteries and replace, check they are charged bottom USBC port. Is anything happening when you hold down the power button?
@@the-happy-RC-flyer the screen just powers on and shuts down immediately and repeats the process several times faster
@@the-happy-RC-flyer provide me your email I will provide you the video of the problem
Is there an SDcard in the radio? Check it in your computer please to make sure it is not corrupted? Have you updated the firmware recently?
@@the-happy-RC-flyer the sd card is fine no I didn't update recently
Je laat niks zien, we willen voltage zien in scherm
You just need to add the telemetry sensor to the telemetry screen. Search my playlists on how to do this.