Fuel Maverick 20x10" D538 Wheel (-12mm Offset) and we have had both 35x12.50R20LT Toyo Open Country M/T Tires, and 37x12.5R20 Toyo M/T's Check out the build details here - www.stage3motorsports.com/Stage-3s-2017-F250-6-7L-Super-Duty-Project-Truck.html
This video doesn't give nearly enough detail on the install. It took me 6 hours to put on the four fender flares because of poor hardware, poorly drilled holes and bad design.
@@bendover-yr4oq Your name is apt... There's no reason to take it in the ass for any company; if you're going to make an installation video, do it well.
The factory hardware is junk. Had mine dealer installed 3 times, and had to re paint the truck because the don't mount tight and rubbed the paint off. Final time I installed them using riv nuts and 3m double stick tape in place of the rubber seal.
![[UNCUT] The Loyal Pin ปิ่นภักดิ์ EP.15 (2/4)](http://i.ytimg.com/vi/qbHbshrA1f0/mqdefault.jpg)
Do you happen to remember what that color gray was called?
Ashton Grey
@@KyleMayad thanks but I sold it 2 days ago..
What are the wheels and tires on this truck?
Fuel Maverick 20x10" D538 Wheel (-12mm Offset) and we have had both 35x12.50R20LT Toyo Open Country M/T Tires, and 37x12.5R20 Toyo M/T's
Check out the build details here - www.stage3motorsports.com/Stage-3s-2017-F250-6-7L-Super-Duty-Project-Truck.html
Thank you! They look perfect with the flares.
How much flare does this give the superduty ?
1.8 inches.
Don’t use detail spray. Use a wax an grease remover before installing
This video doesn't give nearly enough detail on the install. It took me 6 hours to put on the four fender flares because of poor hardware, poorly drilled holes and bad design.
Jason Smith at least they took the time to make a video 🤷🏽♂️. You act like it’s there fault it took you 6 hrs 😂 on a product that’s not there’s
@@bendover-yr4oq Your name is apt... There's no reason to take it in the ass for any company; if you're going to make an installation video, do it well.
The factory hardware is junk. Had mine dealer installed 3 times, and had to re paint the truck because the don't mount tight and rubbed the paint off. Final time I installed them using riv nuts and 3m double stick tape in place of the rubber seal.
How is axle rap with lift? Would it be better with the recoil traction bar from bds?