Check the bulb, also check the contact in the light socket as well. If a previous bulb was screwed in too tight it can push down the contact so it doesn't make a good connection. Pry it up a little with s flat head screwdriver and put the bulb back in. MAKE SURE YOU UNPLUG THE OPENER BEFORE FIRST.
So my wife ran into the garage door, it knock the rollers off the rails but got them back in and I closed and opened the door with the openers, once it binded up, they now don't work. No noise or anything, like its not even getting signal.. Even after I straighten out the doors it doesn't bind up any longer. The buttons manual opener on the machine it self does work though. Just not the remotes even on the wall. Any thoughts...?
Sometimes with the newer electronic limits sometimes they need to be reset after the door is stuck or tried to open a broken door. I would try to unplug and re-plug in and reset the limits once the door is rolling properly by hand. Could have been some permeant damage to the opener, but tough to say without being there to diagnose properly.
Ty for this!
My light bulb was flickering what could be the cause
Check the bulb, also check the contact in the light socket as well. If a previous bulb was screwed in too tight it can push down the contact so it doesn't make a good connection. Pry it up a little with s flat head screwdriver and put the bulb back in. MAKE SURE YOU UNPLUG THE OPENER BEFORE FIRST.
So my wife ran into the garage door, it knock the rollers off the rails but got them back in and I closed and opened the door with the openers, once it binded up, they now don't work. No noise or anything, like its not even getting signal.. Even after I straighten out the doors it doesn't bind up any longer. The buttons manual opener on the machine it self does work though. Just not the remotes even on the wall. Any thoughts...?
Same thing happend today to my door. Still calling to fix
Sometimes with the newer electronic limits sometimes they need to be reset after the door is stuck or tried to open a broken door. I would try to unplug and re-plug in and reset the limits once the door is rolling properly by hand. Could have been some permeant damage to the opener, but tough to say without being there to diagnose properly.
Speaking of garage door opener problems. Have you had any issues with the 98022?
Not me personally but there were software issues on the early models. Supposedly if you connect to myQ it will automatically update the firmware.