Nice install. Are those tubes welded to the center section? Hard to tell in the video. I’m willing to bet those tubes moved. As long as you straighten and weld those 9” ends with a jig you should be good.
Crusader Garage - Nice I’ll have to subscribe and take a look. Right now I just ordered a 6 point roll bar and I’m using relocated uppers. Running a 10:1 331 all motor. We only have an 1/8 mile track. Best so far 7.63 @ 91.8 mph. Depending on how this COVID BS goes, I plan I’m doing thru the floors subs, roll cage, upper and lower tq boxes, mini tubs, and coil overs. Then new 351 based stroker. Your vids will come in handy I’m sure. Did you go with the team z cage?
Crushing it man! Awesome video, super informative
Thanks. I have a lot more work to do. Coming soon
hey bud can you still use the stock fuel tank in the stock location with that kit installed, thanks man great work.
I’m not sure brother. I’m using a fuel cell. Sorry.
Nice install. Are those tubes welded to the center section? Hard to tell in the video. I’m willing to bet those tubes moved. As long as you straighten and weld those 9” ends with a jig you should be good.
The tubes are welded. And the ends were welded in I jig I have. Thanks for watching
Crusader Garage - Awesome. I didn’t realize that it was done already. Did you do a video on it? Did you use the Team Z 8.8 brace?
I did. I narrowed the rear end, did torque boxes and a roll cage. All videos on my channel.
Crusader Garage - Nice I’ll have to subscribe and take a look. Right now I just ordered a 6 point roll bar and I’m using relocated uppers. Running a 10:1 331 all motor. We only have an 1/8 mile track. Best so far 7.63 @ 91.8 mph. Depending on how this COVID BS goes, I plan I’m doing thru the floors subs, roll cage, upper and lower tq boxes, mini tubs, and coil overs. Then new 351 based stroker. Your vids will come in handy I’m sure. Did you go with the team z cage?
Yes. Pretty much used all TeamZ parts. Their brace kit, upper torque boxes, full cage, through the floor frame connectors and so on.
Thanks man
Thanks for watching 👍
Do you remember off hand what the measurements was from the housing to flanges?
For the coil over brackets, I don’t. Sorry.
Thats what you get! Talking that smack!
Hahahaha. I knew you would make a comment