I just did this job on my two thousand 15 Nissan Rogue this past weekend. All this work is completely unnecessary all I did was remove the glove compartment unscrewed the 6 or 7 screws holding the glove compartment housing so that it's able to be moves slightly. Then I basically just stuck my hand up there and unscrewed the 1 screw holding the blower motor in place. The tough part is turning the blower motor counterclockwise, what I did was use a screwdriver and a hammer and kind of tapped it out of place or counterclockwise and it came loose. Then because you unscrewed all the housing screws you got a little wiggle room to push the dash outwards as you're bringing down the broken blower motor with just enough room to pull it out. You install the new one in reverse. All I ended up removing was the glove compartment container and unscrewing those six or seven screws oh, a what seems like to be a 3 hour job turn into a one-hour job.
May i ask what your issues were for needing to replace? Mine just started to stop blowing put cold air after about 20 min. If I shut off a.c for 5min and turn back on it works for about 20 min then stops blowing. The sound of the blower doesn't change at all the whole time...
More than one way to skin a 🐈. I used his video got the job done like hundreds of other people that watched this video. Stop raining on someone's parade 😒.
Primero que nada que maravilloso es personas como usted que comparten su talento. Muchas gracias!Tengo una Nissan Rouge 2013. He visto varios vídeos . Unos enseñan como sacarlo por la gaveta y otros por el pedal de gasolina. Ya compré el abanico. Es blanco y más pequeño y cuando lo sacan desde donde está la gaveta que es negro yo más larga. Su video es de una Rogue de 2014. El otro vídeo es desde Rogue del 2013 en adelante. Estoy súper confundida.
Thank you very much for this video! Was dreading this job and it only took me about 45 minutes from start to finish! Missed two screws but quickly located them. Very informative! Thanx again!!!!!
Thank you. Very clear and precise. Unfortunately it took me far longer - 1 hr. Turns out a mouse built a home in the fan and used the battery insulation as additional material
Great video he missed two screws on the upper part of the glove box after you remove it and I recommend removing the second bottom Radio head screw on the left to slide the middle dash piece above the glove box back into place easier
Yo lo cambie y no se necesita quitar todo como en el video y eso lo muestran asi para que el cliente lo vea complicado yo solo tarde 20 minutos en quitarlo y otros 20 minutos instalandolo por inspection en el dealer $152 dolares mas la parte,mas el trabajo y llega un promedio de $500 a $600 dolares saludos subire el video esten atentos
You guys with left hand drive cars are lucky. RHD cars have to have the steering column removed or moved to replace the fan. Mine fan was noisy and the Nissan dealer did it under warranty. But what a silly location for it.
😂 It's so funny I got my blower motor replaced and the resistor replaced just yesterday and they told me that my blower motor for a Nissan Rogue is not in a usual spot like other cars it's pretty out of the way which makes it a lot more labor-intensive so I had to look at the video to see what they meant oh my God they had to take my car Part
Bueno yo compre un blower remplazo porque el aire dejaba de enviar el flujo de aire y pense que era el blower, pero decidí llevarlo a un técnico y resultó que no era el blower sino una válvula que ahora mismo no recuerdo el nombre pero la cambiaron y todo funcionó pero el flujo de aire no era el mismo de antes y decidí montar el blower original que había remplazado y ahí si funciono ,el flujo era fuerte como antes .....cual es mi recomendación, traten de montar el blower original, no remplazo.
Buen dia yo tengo una nissan quest a la cual le cambie la resistencia, encendi la camioneta para probarla por unas 2 veces y funciono correctamente, el blower no encendia hasta que yo rotaba el control, pero ya a la tercera ves que encendí la camioneta ya se quedaba encendido el blower al máximo aun con el control del clima apagado, que podrá ser por que la resistencia es nueva.
Buenas tardes, tengo una nissan rouge 2014, todo jalaba bien. El clima, caliente y frío, pero ya no sale nada de aire, todo seve que prende, en el control , pero ya no sale nada de aire ni frío ni caliente, ya le cambie el filtro , pero nada .
Yes, if your Nissan Rogue is LHD .. the blower motor resistor is located on the driver side you will have to remove the gas and brake pedals to get. There's a very helpful video in TH-cam showing how to do it.
We may not speak same language but your video was very good!! Thank you!! Gracias
I just did this job on my two thousand 15 Nissan Rogue this past weekend. All this work is completely unnecessary all I did was remove the glove compartment unscrewed the 6 or 7 screws holding the glove compartment housing so that it's able to be moves slightly. Then I basically just stuck my hand up there and unscrewed the 1 screw holding the blower motor in place. The tough part is turning the blower motor counterclockwise, what I did was use a screwdriver and a hammer and kind of tapped it out of place or counterclockwise and it came loose. Then because you unscrewed all the housing screws you got a little wiggle room to push the dash outwards as you're bringing down the broken blower motor with just enough room to pull it out. You install the new one in reverse. All I ended up removing was the glove compartment container and unscrewing those six or seven screws oh, a what seems like to be a 3 hour job turn into a one-hour job.
May i ask what your issues were for needing to replace? Mine just started to stop blowing put cold air after about 20 min. If I shut off a.c for 5min and turn back on it works for about 20 min then stops blowing. The sound of the blower doesn't change at all the whole time...
@@bashunov456 same problem with mine, have you had it replaced?
@@theffzaesparis no, it ended up just fixing itself but I sold the car
So you didn't change your resistor?? I have a 15 as well and all sudden just quit blowing there's cold air just no Moro to push it
More than one way to skin a 🐈.
I used his video got the job done like hundreds of other people that watched this video.
Stop raining on someone's parade 😒.
Primero que nada que maravilloso es personas como usted que comparten su talento. Muchas gracias!Tengo una Nissan Rouge 2013. He visto varios vídeos . Unos enseñan como sacarlo por la gaveta y otros por el pedal de gasolina. Ya compré el abanico. Es blanco y más pequeño y cuando lo sacan desde donde está la gaveta que es negro yo más larga. Su video es de una Rogue de 2014. El otro vídeo es desde Rogue del 2013 en adelante. Estoy súper confundida.
Thank you very much for this video! Was dreading this job and it only took me about 45 minutes from start to finish! Missed two screws but quickly located them. Very informative! Thanx again!!!!!
Very good video. The directions were very good. I know a little Spanish so I was able to follow the instructions. Thanks for saving me a lot of money.
Thank you. Very clear and precise. Unfortunately it took me far longer - 1 hr. Turns out a mouse built a home in the fan and used the battery insulation as additional material
Great video he missed two screws on the upper part of the glove box after you remove it and I recommend removing the second bottom Radio head screw on the left to slide the middle dash piece above the glove box back into place easier
Going to have to do this repair myself.
Thank you for the excellent video!
Muchas Gracias Senior, Viva Los Trabajadores!
Yo lo cambie y no se necesita quitar todo como en el video y eso lo muestran asi para que el cliente lo vea complicado yo solo tarde 20 minutos en quitarlo y otros 20 minutos instalandolo por inspection en el dealer $152 dolares mas la parte,mas el trabajo y llega un promedio de $500 a $600 dolares saludos subire el video esten atentos
No es necesario desarmar todo eso basta con sacar la pantera gracias por el video saludos y bendiciones
Muchas gracias por el video!! Me ahorro muchas horas de frustración y también dinero. Bendiciones a ustedes ❤️
Excellent video it was a big help with our blower motor replacement.
Great step by step, very helpful. Thank you
Thanks so much for making this.
Aplica también para Nissan X-trail
Thank you very much. It made the job possible. Muchas Gracias!!! Yo hablo Espanol pequeno.
You guys with left hand drive cars are lucky. RHD cars have to have the steering column removed or moved to replace the fan.
Mine fan was noisy and the Nissan dealer did it under warranty.
But what a silly location for it.
😂 It's so funny I got my blower motor replaced and the resistor replaced just yesterday and they told me that my blower motor for a Nissan Rogue is not in a usual spot like other cars it's pretty out of the way which makes it a lot more labor-intensive so I had to look at the video to see what they meant oh my God they had to take my car Part
Mil gracias me fue super útil gracias a tu vídeo lo pude cambiar se te agradece
Thank you for the video it really helped
Wow, you could of just took the glove box off instead of taking the entire car apart...
Lol
I've seen a few videos and they all remove the same parts.
Thanks super helpful. Mucho gracias
Muy buen video. Gracias me ayudo mucho como referencia cuando cambié el blower motor de mi nissan rogue. Gracias 🙏
Gracias por tu ayuda!
Thanks for your help!
Thank you. This helped me a lot!
Thank you!!!!!!!!!!!!!!!!!!!!!
Gracias x tu video fue muy util .
This video makes me want to do this repair myself then go to a Mexican restuarant when I'm done and have a burrito and a corona
Bueno yo compre un blower remplazo porque el aire dejaba de enviar el flujo de aire y pense que era el blower, pero decidí llevarlo a un técnico y resultó que no era el blower sino una válvula que ahora mismo no recuerdo el nombre pero la cambiaron y todo funcionó pero el flujo de aire no era el mismo de antes y decidí montar el blower original que había remplazado y ahí si funciono ,el flujo era fuerte como antes .....cual es mi recomendación, traten de montar el blower original, no remplazo.
Thank you!!
Lo maximo muchas gracias por el video .
Hi ! Is it, may be, the same with Qashqai J11 2015?
Thanks!
Gran referencia ¡¡Muchas gracias!!
Thanks great job
Well done amigo's 🤙
You do not need to take that much plastic off js
Ok, Now come and change my out for a case of beer...
A case of beer ??? Que tipo tan patético eres vales verga !!
Best video
Buen dia yo tengo una nissan quest a la cual le cambie la resistencia, encendi la camioneta para probarla por unas 2 veces y funciono correctamente, el blower no encendia hasta que yo rotaba el control, pero ya a la tercera ves que encendí la camioneta ya se quedaba encendido el blower al máximo aun con el control del clima apagado, que podrá ser por que la resistencia es nueva.
do you know where is blend door acturator located?
Alguien que sepa hacerlo así como tú sin lastimar el tablero acá en Guadalajara Jalisco? Excelente trabajo
Amigo nice job but looks like you are little rough on those plastic parts …
Buenas tardes, tengo una nissan rouge 2014, todo jalaba bien. El clima, caliente y frío, pero ya no sale nada de aire, todo seve que prende, en el control , pero ya no sale nada de aire ni frío ni caliente, ya le cambie el filtro , pero nada .
Scusatemi ma la resistenza della stufa abitacolo dov'è posizionata !!
How to remove the Evaportor ?
Hi, Does anyone know where the heater blower resistor is located on this model. I can't find any information anywhere.
Yes, if your Nissan Rogue is LHD .. the blower motor resistor is located on the driver side you will have to remove the gas and brake pedals to get. There's a very helpful video in TH-cam showing how to do it.
How I remove evaporator nissan x trail T32
or how clean it
Too much work in the winter, for me to do it outside with no garage
For Sandero
2011
Este no es profesional con ese relajo seguro al poner todo en su sitio algo va a faltarle y algo va a quedar flojo 😌
This is why we don't buy Nissans, people..
Thank so much; your video was a great help!