The Electric Shift Models didn't use Solenoids to shift, but used an Electromagnet to draw a Spring across a Hub, where the Spring would Grab a Hub inside it
So I have a 66 same motor and im getting fuel going into the filter but its not coming out .. any ideas why its clean had it apart.. but getting no fuel from the out line to the motor at all
Hay I just the same motor. been sitting for 10 years. it turns and may start I got a new Water Pump Impeller on order . Gee the same hole on the side of the motor as yours . what is it for? I only have $150 in it right now . If it don't run going to part it out . I do not have a boat to put it on but I can get one .
@pjimmbojimmbo1990 if I recall correctly if you look straight down that hole there is a bolt head sticking up. You can go down that hole with a socket and extension to get it out. Otherwise you have to unbolt all the bolts that hold that back cover on.
I have a 64 seahorse 40hp purrs like a loud kitty! Sat for 7 years and fired right up. strong motors
Unfortunately this one had a knock, I have swapped on another powerhead but haven't started it up yet.
The Electric Shift Models didn't use Solenoids to shift, but used an Electromagnet to draw a Spring across a Hub, where the Spring would Grab a Hub inside it
So I have a 66 same motor and im getting fuel going into the filter but its not coming out .. any ideas why its clean had it apart.. but getting no fuel from the out line to the motor at all
Fuel pump bad or stuck float/needle?
Hay I just the same motor. been sitting for 10 years. it turns and may start I got a new Water Pump Impeller on order . Gee the same hole on the side of the motor as yours . what is it for? I only have $150 in it right now . If it don't run going to part it out .
I do not have a boat to put it on but I can get one .
I have just got one of these in need of restoration did you manage to get this one working?
+ben hale yes and no, got it running but the powerhead was knocking. I picked up a powerhead on eBay and need to finish installing it.
That looks like a old johnson super sea horse ?
I think the sea horses were made prior to this evinrude.
Same Motor, in 67 Evinrude did paint a lot of Motors White.
I don't understand why someone would knock a big Hole in the Rear Cover, it would serve no Purpose
Looks like they did it for easier access to the bolts on the lower unit.
@@mjmcomputers
The Hole isn't big enough to swing a Wrench or Ratchet to remove the Bolt in that area.
@pjimmbojimmbo1990 if I recall correctly if you look straight down that hole there is a bolt head sticking up. You can go down that hole with a socket and extension to get it out. Otherwise you have to unbolt all the bolts that hold that back cover on.
That hole shouldn't be there. The casting is corroded.
The hole is threaded.