ESC Calibration | Quick Tip | Motion RC

[@WiliiamNoTell]

Straight forward and to the point, thank you so much

[@RichardJones-fr7xn]

How simple and I feel like a bum ass thanks quick and to the point without over explaining

[@khanhla6673]

I’m currently using a TivaC microcontroller instead of a remote transmitter. Pleas tell me how I can caliberate the ESC through a microcontroller..

[@nemonespider]

Got a question…. I’m getting the fast beeps trying to set up a T45 I’ve tried the throttle calibration but still no luck any tips on how to resolve this

[@christopherpennell-x1z]

Thanks so much Wes🏆

[@davidgerlach1132]

Curious, at 3:32 you corrected it, but isn't the question why did it happen to begin with?

[@Shauncat1]

Thanks Wes 🙏

[@stevejamelskyj5761]

Hi I've just done what u suggested it's still beeping fast any ideas

[@HAWAII-uh7sc]

Brother, I have a question. I have a new P40 Warrior.
When I go to calibrate Esc throttle, I don't have any beeps. How come it won't beep?

[@johnmarkham4861]

How about if after you calibrate and the esc will let you run throttle once up then back to low then shuts down meaning no throttle then I have to reboot tx and rx to have throttle again only having to repeat the steps
Can you help

[@tboystoys5682]

I have an FMS f4u Corsair 800mm RTF and tried an esc calibration like the way you show but I can’t get it to calibrate that way. Is there another way of doing it for those planes

[@edge1324]

Appreciate ya! 👍🏻

[@robertchapman7773]

Thanks Wesley

[@3oneight]

Does it work with a brushed esc?

[@jesusrrodriguezl7455]

Excelente Tio

[@sendit_rc]

Throttle cut off correct then stick all the way up til two tone beep and then down to zero throttle.

[@MotionRC]

Yes and remove the propeller always!

[@MichaelSmith-yx8nn]

Thanks, I thought my ESC was defective...