Yo bro. I experienced this same issue at the start. BUT, ensure you're running all the units on the latest firmware Pyro H_H100_V1.0.3.6. You can also place each set into separate groups to isolate multiple units from each other. Keep devices 2 feet away from each other. No more problems.
Hey my transmitter fan is kinda loud but receiver fan is silent. is this normal? The transmitter sitting on the camera has this subtle crackling noise where the fan is. sounds a bit like if you would put the needle on a record with the record rotating but no music playing from the record player even when fan set on low. is this normal? Does your transmitter and receiver fan sound the same?
![สาวเมืองเพชร - ธีเดช ทองอภิชาติ [Official MV]](http://i.ytimg.com/vi/kEt7F9PvO3I/mqdefault.jpg)
Same issue, very frustrating
Yo bro. I experienced this same issue at the start. BUT, ensure you're running all the units on the latest firmware Pyro H_H100_V1.0.3.6. You can also place each set into separate groups to isolate multiple units from each other. Keep devices 2 feet away from each other. No more problems.
I suspect firmware updates as well
I had to pair them manually by getting close to eachother then after pairing I go back to my setup
Hey my transmitter fan is kinda loud but receiver fan is silent. is this normal? The transmitter sitting on the camera has this subtle crackling noise where the fan is. sounds a bit like if you would put the needle on a record with the record rotating but no music playing from the record player even when fan set on low. is this normal? Does your transmitter and receiver fan sound the same?
@@ThatGuyOverThereWeird yeah there’s a bit of an issue either the Boris has worned
I have this system and this has happened to me also on set. At home it works fine. Not sure what the issue was.
Nice gadgets
Oh thanks darling …. I need more!!!😂😂😂
I haven’t experienced such though
You haven’t to experience it in Jesus name😂😂😂
If it ever happens you only have to rescan available channels
I actually did that but nothing changed
Just out of interest, did you use the same HDMI cables on the test as you did when it failed? Could that have been the problem?
Yes I did… Everything used was same things used on site…
You must give a space between TX and RX. Test it in real world.