Forward & Reverse Lever Support Bracket EP10

In This Episode I Make the Forward & Reverse Lever Support Bracket EP10
#Machining
#Stuart 10v
#Steam Engine
#Milling
#Steam Ports

[@nobbysworkshop]

Some great set-ups there Mark. I'm learning some useful tips from you. ATB Cheers Nobby

[@EnglishHobbyMachinist]

Thanks Nobby 👍

[@djhscorp]

Always interesting to watch.

[@EnglishHobbyMachinist]

Thank you

[@mikechadwick3340]

Nice one Mark, looking forward to having a go at this piece . Thanks for the video.

[@EnglishHobbyMachinist]

When you get to this part, use a rotary table if you have one, I got a bit lazy and didn’t want to setup the rotary table but wished I had, halfway through 😂

[@mikechadwick3340]

Thanks will do

[@joell439]

👍👍😎👍👍

[@EnglishHobbyMachinist]

👍

[@gregwmanning]

Welldone, that was a very fidderly piece

[@EnglishHobbyMachinist]

Thank you 👍

[@RB-yq7qv]

[@memememe2674]

I know it's your choice, but I have seen you you a rotary tab. Why not use that much easier

[@EnglishHobbyMachinist]

I got lazy 😂 and couldn’t face taking the vice off, aligning the table and then putting the vice back on the mill, for what appeared to be a small job! As it turned out, it took twice as long 🤦‍♂️ moral of the story, don’t be lazy!😂😂

[@paulrayner4514]

I assume you haven't a rotary table?

[@EnglishHobbyMachinist]

I have 2 rotary tables but decided to do it this way! but wish I had used the rotary table by the time I was halfway through 😂

[@paulrayner4514]

@@EnglishHobbyMachinist Ok. must admit I was expecting it to come flying out of the 4 jaw, especially with it being soft ali. I was clenching my buttocks for you! well done👍

[@EnglishHobbyMachinist]

@@paulrayner4514 😂