I had to use 14 for 15 pair . It ran like crap , got hot 🔥 shut down . I hooked up the second controller, and wheel . Now it is so dangerous, and hard hold on to!!! It does not like just one ! It is exponentially better ,and runs cool.
Very strange. Pole pairs won’t affect the controller normally. So it means something else in settings didn’t work with that motor. If it ran like crap then most likely it never paired correctly, which it would do even at 4 pole pairs. If it did pair correctly and still running bad, then PID settings were probably off. Which controller did you connect that worked good? Was it also FOC? Sine wave? Designed specifically for that motor?
@@imho7250 the Fardriver nd84530s now working too good ! I found it super hard to let off the twist throttle! I almost crashed . Also I have very strong 💪 . That's how hard it pulls now
0:00 align references points to know when its rotated exactly 360 degrees.
0:15 short any two phase wires together, ensuring the 3rd wire is not touching anything.
0:20 briskly but gently rotate the motor, counting each resistance point you feel.
0:30 1, 2, 3, 4, 5, 6, 7, 8, 9, 10….
0:35 11, 12, 13, 14, 15, 16, 17, 18, 19, 20…..
0:39 21, 22, 23, 24, 25, 26, 27, 28, 29, 30….
0:44 31, 32, 33, 34, 35, 36, 37, 38, 39, 40 pole pairs.
Mine have 60 resistance aftar full 360 degree rotation.. So means it is 30 pole pairs right?
Probably but you can also verify with reported rpm, your tire diameter, and gps verified speed
I had to use 14 for 15 pair . It ran like crap , got hot 🔥 shut down . I hooked up the second controller, and wheel . Now it is so dangerous, and hard hold on to!!! It does not like just one ! It is exponentially better ,and runs cool.
Very strange. Pole pairs won’t affect the controller normally. So it means something else in settings didn’t work with that motor. If it ran like crap then most likely it never paired correctly, which it would do even at 4 pole pairs. If it did pair correctly and still running bad, then PID settings were probably off.
Which controller did you connect that worked good? Was it also FOC? Sine wave? Designed specifically for that motor?
@@imho7250 the Fardriver nd84530s now working too good ! I found it super hard to let off the twist throttle! I almost crashed . Also I have very strong 💪 . That's how hard it pulls now
@imho7250 thanks for your previous help