DIY-How to make time delay relay circuit using 555 timer ic | 5 minute timer circuit

we are going to show you how to make a Time delay relay circuit using a 555 timer IC. This circuit is able to trigger the relay from a few seconds to a few minutes after pushing the Switch S1. It is easy to make and uses only a few components.
A relay is a switch that is operated electrically between two terminals that are, normally closed and normally open. This depends on the energizing and de-energizing of the coil in the relay. There are some relays in which the switching process is not immediate and takes time, they provide a “time delay” between the energizing and the de-energizing of the coil. These relays are called Time Delay Relays that we are going to use today.
The main difference between these relays is that normal relays switch from a normally close terminal to a normally open terminal immediately whereas in time delay relays the contacts are closed or open only after a preset time interval.
Components Required:
1- NE555 timer
2- 10k Ohm
3- 220 Ohm
4- Status LED
5- 6V Relay
6- Vero Board
7- 1000uF Capacitor
Like Share and Subscribe Electronic_Junction
#circuit #electronic #electrical #electricity #555timer #555 #ne555 #timer #relay

[@gopnik603]

thank you sir!

[@VamshiKrishna-zh3zl]

Hi, how to make this with 3 phase supply without neutral. Actually I'm having a 3 phase motor, when the motor turns on, I want to turn on the capacitor as well but with a delay of 1-2 min, can you pls guide me in this.

[@motiramgangurde5844]

Very good👍 sar

[@electronic_junction23]

Thanks and welcome

[@l1t55f1b9o4un1bu2a3a]

This is beautiful. Can you do a video showing connectiona digital timer to the circuit to display the time of delay

[@electronic_junction23]

Video coming soon

[@boopeshkumarprabhakaran]

circuit diagram says 57k resistor and 10k what about potentiometer and can i supply 5v power supply instead of 12v?

[@electronic_junction23]

57k is tuned for 1 minute timer instead use a potentiometer of rating 1M to get variable delay time upto 5 minutes. And yes you can use source voltage depending on Relay Voltage if your relay has 6V rating or 12V rating use the source accordingly.

[@muazhamid1160]

Music>>>>>>>>>>>>>>>>>>>>>>

[@TheFandiahmad]

Can we replace relay and use mosfet ?

[@electronic_junction23]

Using Relay you can switch between two states. While on the other-hand, a mosfet serves a different purpose. It's used for switching based on frequency however you can also use it as a switch here in circuit. But Relay is more preferable.

[@TheFandiahmad]

@@electronic_junction23 ok thanks for information sir 🙏👍👍

[@srinivasraoch.9628]

Controle connection missed in circuit diagram

[@electronic_junction23]

Connection is super easy. Just Connect Load and Source in series with the relay. As demonstrated in video

[@bamshisentatrihisentatri6477]

Berguna tapi cara penyambungan kurang jelas..mohon info

[@electronic_junction23]

1:03

[@TPRDIY]

Bro diagram plzz

[@electronic_junction23]

1:04

[@Sam_lyf_]

Isko agar 20mins delay karna joga to kya karu

[@electronic_junction23]

Yes Possible, Simply replace 1M Variable Resistor to 2.2M