Mercedes A-Class (W176) How to remove rear bumper

แชร์
ฝัง

ความคิดเห็น • 29

  • @dankey3346
    @dankey3346 ปีที่แล้ว +4

    Thanks for the video, straight to the point on what you need to do. Need more videos like this!

    • @jackgross3140
      @jackgross3140  ปีที่แล้ว

      I’m glad this helped. Thank you for taking your time out to leave such positive feedback! Much appreciated 🙏

  • @michalm946
    @michalm946 10 หลายเดือนก่อน +1

    Thank you for this great video!

  • @metty9065
    @metty9065 ปีที่แล้ว

    Thank you this helps me a lot to install a hitch 👍

  • @eastcoastuk9705
    @eastcoastuk9705 9 หลายเดือนก่อน +1

    Top vid great simple info thanks for sharing.

    • @jackgross3140
      @jackgross3140  9 หลายเดือนก่อน

      Thanks for the feedback! Glad it’s helped out 🙏

  • @josimargonzalezjaimes7918
    @josimargonzalezjaimes7918 3 หลายเดือนก่อน

    Que medida son los rebites de plástico?

  • @ghost_marclv_5453
    @ghost_marclv_5453 11 วันที่ผ่านมา

    Thanks

  • @philmelvin7934
    @philmelvin7934 ปีที่แล้ว +1

    🙏🏻 detailed

  • @grupinfractionalorganizatp5003
    @grupinfractionalorganizatp5003 5 หลายเดือนก่อน

    hi
    what device are there yellow after open that plate in the trunk ?

  • @glueh
    @glueh 9 หลายเดือนก่อน +1

    I love you bro ❤

  • @Marcesko
    @Marcesko ปีที่แล้ว +1

    Nice! Thank you! Great camera work and straight to the point.

  • @marcomj8791
    @marcomj8791 ปีที่แล้ว +1

    I have a 2018 amg line same as yours rear diffuser to replace oem to oem, can it be replaced without removing the bumper?

  • @teo.junhao
    @teo.junhao 11 หลายเดือนก่อน +1

    can I check what size is the torx screw please?

    • @jackgross3140
      @jackgross3140  11 หลายเดือนก่อน +1

      T40 inside the boot holding the hooks on the trim panel

    • @teo.junhao
      @teo.junhao 11 หลายเดือนก่อน

      @@jackgross3140 thank you!

  • @jakegrace79
    @jakegrace79 5 หลายเดือนก่อน

    Great vid ,but just need a bit of info on a tool you use ? We’re at the bit where your in the boot and have popped out the plastic ‘ guard ‘ where the boot latch is . Then you pull out the 2 rubber plugs and have to unscrew a small bolt which is located at the end of a long pin ! Is that a spark plug spanner ? If not , do you know what it’s called and size? Ta !

    • @jackgross3140
      @jackgross3140  5 หลายเดือนก่อน +1

      Hey, it is an extra deep 10mm socket to remove the 10mm nuts. You can tape a couple of deep 10mm sockets together if you don’t have a super deep one

    • @jakegrace79
      @jakegrace79 5 หลายเดือนก่อน

      @@jackgross3140 thanks for the info , great tip about taping them together !!!!

    • @jackgross3140
      @jackgross3140  5 หลายเดือนก่อน +1

      @@jakegrace79no worries! They are usually not very tight from the factory, just tightly wrap some tape around the two sockets and it should fit over the threaded bar👌

    • @jakegrace79
      @jakegrace79 5 หลายเดือนก่อน +1

      Daughters had the car 3 years , suddenly noticed wet rear carpets . Bit of searching and found it may be the 2 air vents behind the bumper ( hence your vid being handy !) . Gonna replace them , in your opinion is this likely to be the problem ??

    • @jackgross3140
      @jackgross3140  5 หลายเดือนก่อน

      @@jakegrace79 hey thanks for the feedback!
      100% the rear vents will be the cause of this as it is a common issue with the 176 A class!
      Most, if not all of them will have been affected with this problem by now.
      You can use silicone sealant to seal around them to prevent any water coming in

  • @the_fearless_explorer1213
    @the_fearless_explorer1213 ปีที่แล้ว +2

    What socket did you use pls

    • @jackgross3140
      @jackgross3140  ปีที่แล้ว +2

      Snap on extra deep 10mm

    • @the_fearless_explorer1213
      @the_fearless_explorer1213 ปีที่แล้ว

      @@jackgross3140 thanks a lot

    • @Paulpenuk
      @Paulpenuk 7 หลายเดือนก่อน

      ​@@jackgross3140do you know the part number please ?