Thanks, I'm glad I could help. That's why I made it. This was filmed when I was new to these bikes, and I decided to demonstrate what I was doing for others.
Fillman Machining. you can find him on line, Email-david@fillmanmachining.com or Cell: 610-310-7312Phone hours: Monday through Friday 5:00 PM to 8:00 PM EST Saturday 8:00 AM to 5:00 PM EST
Good morning Commander, well I got the fill and fill to here plug out, drain plug stripped out. Have watched how you got fill to here plug out. Drilled a hole thru skid plate to access drain plug, have used heat, BP blaster, and easy out with no success. What size drill bit did you use, regular or left turn. Do you drill all the way thru, did you finish extraction with needle nose or use an easy out. My dread is messing up the threads, were you able to use the original threads. Again, thanks for your videos.
Thanks for the video.....
Thanks, I'm glad I could help. That's why I made it. This was filmed when I was new to these bikes, and I decided to demonstrate what I was doing for others.
Incredibly helpful. Thanks for doing this!!
I'm glad I could help. The basket case is getting closer. I have had a few set backs. Its had some modifications.
Your welcome. I was hoping what was going through could help someone else.
Enjoyed the video Commander, looking to buy new transmission drain plugs, any suggestion on where to purchase 18 x 27 NPT. Thanks, Jerry
Fillman Machining. you can find him on line, Email-david@fillmanmachining.com or Cell: 610-310-7312Phone hours: Monday through Friday 5:00 PM to 8:00 PM EST Saturday 8:00 AM to 5:00 PM EST
Thanks much.
When mounted on our Rokons the transmission is at an angle to vertical. Have wondered if fill olug assumes angle or straight up and down vertical?
I don't know. Sorry
Good morning Commander, well I got the fill and fill to here plug out, drain plug stripped out. Have watched how you got fill to here plug out. Drilled a hole thru skid plate to access drain plug, have used heat, BP blaster, and easy out with no success. What size drill bit did you use, regular or left turn. Do you drill all the way thru, did you finish extraction with needle nose or use an easy out. My dread is messing up the threads, were you able to use the original threads. Again, thanks for your videos.
I'm sorry I missed your message. I assume you've finished that mess by know. I hope it running like a champ now.
Yes, got it done. Thanks again.
Good video, job would be easier on the work bench,remove chain,belt, roll pin and 4 bolts
I was limited to space. It would have been nice. Thank you