@@gentrycustomknives8008 I also cut a sharpening notch in I take it to the bandsaw and make a small cut where I want it,that gives me a notch for my file to ride in. Thanks again
@@gentrycustomknives8008 I also cut a sharpening notch in I take it to the bandsaw and make a small cut where I want it,that gives me a notch for my file to ride in. Thanks again
Nice! The only part of my shop that looks like yours is the hand sanding station lol.
Lol nice!
Greetings from the uk absolutely love this build haven’t got san mai only 1080 but going to give it a go based on watching this 🇬🇧👍🏻
I'm jealous of your drawer full of handle material!!
Lol thanks man I’ve collected some nice stuff over the years!
Like this handle ... awesome...!
Thank you!
Awesome piece of craftsmanship, looks like you're enjoying using the disc sander.👌
The disc sander has been an awesome upgrade to the shop! Thanks for checking out the build!!!
A winner 👍 on the blade and tunes
It’s hard picking 20 minutes of songs lol. Glad you enjoyed it!
@@gentrycustomknives8008 I also cut a sharpening notch in I take it to the bandsaw and make a small cut where I want it,that gives me a notch for my file to ride in. Thanks again
@@gentrycustomknives8008 I also cut a sharpening notch in I take it to the bandsaw and make a small cut where I want it,that gives me a notch for my file to ride in. Thanks again
Gorgeous build! Always love watching you create ✌️
Thank you!! 👊👊👊
That's a beauty!
Thank you!
What a beauty! Love this kind of videos keep it up!
Thank you!!!
Hmmmm, slicey!!!! 👍🏻
Thanks for watching!
Nice job editing!and beautiful knife!well dine!
Really appreciate that! Thank you for watching!
File the sharpening choil after bevellling
Why
Looks good man!
Thank you!!!
Beautiful blade!! What did you use on the qtip to clean the extra epoxy off?
Thank you! I used lacquer thinner
How much one of them even heat kilns??
Not sure what they run now
Nice, thin and slicey.
Maybe should have surface ground equally on both sides??
The delamination was only on one side though
@@gentrycustomknives8008 yup, that's what I tought afterwards... Still a very nice little knife given the condition of the billet
Sweet. Do u use compound to stick sandpaper on your disc grinder? If so how do u apply it? Thx all the best
So I use 3m feathering disc adhesive for that!
Thx.all the best
Nice vid, what edge thickness do u go to before sharpening?
On this one it was THIN like .005