@@BillyWillicker I only ever raise the intake ports by as much as I need to satisfy port shape so there's never going to be that issue. I do sink the port floors though because intake timing is key in attaining an engine that breathes properly. So its a non issue, but thanks mate
Check to see that the bottom ring gap does not drop below the intake port roof into the port at BDC.
@@BillyWillicker I only ever raise the intake ports by as much as I need to satisfy port shape so there's never going to be that issue. I do sink the port floors though because intake timing is key in attaining an engine that breathes properly. So its a non issue, but thanks mate
@@Vector2strokes Will you be adding boyesen ports to this cylinder?
@@BillyWillicker not for this 1.
Where did you get those long 3mm shanks?!? I've been making extinctions for my 3mm's and they wobble bad.
@@zacharygillette7810 temu has a fantastic selection