Air suspension compressor / valve block replacement Audi Q7 (Part - 1 of 2)

แชร์
ฝัง
  • เผยแพร่เมื่อ 31 ธ.ค. 2024

ความคิดเห็น • 12

  • @bumbleshufflesdiy5908
    @bumbleshufflesdiy5908  10 หลายเดือนก่อน +2

    Thanks very much for watching my video everyone (and don't forget about part 2). If you liked the video please consider subscribing to help me build the channel. Thank you very much.

  • @MrVandammages
    @MrVandammages 4 หลายเดือนก่อน +1

    thanks for this one!

    • @bumbleshufflesdiy5908
      @bumbleshufflesdiy5908  4 หลายเดือนก่อน

      Your welcome and thanks very much for your positive feedback.

  • @sadullahbaksl3872
    @sadullahbaksl3872 11 หลายเดือนก่อน +1

    Selam türksünüz galiba
    Çocuk baba diye seslendi
    Bende arıza için video ya bakıyordum emeğiniz için tşk ler

  • @withYOUin
    @withYOUin ปีที่แล้ว

    I am dealing with a similar issue. Fuses are all fine, compressor kicks on, sprayed the solenoid with soapy water....no leaks. Im at a loss.

    • @bumbleshufflesdiy5908
      @bumbleshufflesdiy5908  ปีที่แล้ว +1

      Have you checked / listened at the four strutts for air leaks?
      Also, is it possible that the compressor is running but not working effectively (I.e. Not pumping air due to worn out seals on the piston ring even though its running)?

    • @bumbleshufflesdiy5908
      @bumbleshufflesdiy5908  ปีที่แล้ว

      Also, in my part 2 video you will see that there is a black air line running from the compressor to the top left of the valve block. Is it possible that there is either a leak on this line or a leak where it connects into the compressor (on the front wheel side of the compressor)?

    • @withYOUin
      @withYOUin ปีที่แล้ว

      @@bumbleshufflesdiy5908 I rechecked each tire, solenoid, and all around the compressor, I think the compressor is not working effectively like you suggested. Thanks for the help.

    • @bumbleshufflesdiy5908
      @bumbleshufflesdiy5908  ปีที่แล้ว

      @@withYOUin no problem at all. When I dismantled my compressor the inside piston was in bad shape. I think mine had been pumping away with a bad seal and subsequently overheated and self destructed. Ps a new compressor from aerosus without bracket is only £252 at present. Massive saving if doing it DIY.

    • @withYOUin
      @withYOUin ปีที่แล้ว

      I put a new compressor in and viola! Car came to life and immediately started raising back up. However, now the right side of the car is in Lift mode ~500mm, and the left side is sitting close to Dynamic 420mm. I have tried re leveling using VCDS and it fails every time. Bled front axle and rear axle, but the right side still sits higher Im stuck, not sure what to do...