Hey hey hey. Just to let everybody know that if you have no voltage on the blue and white wire on the solenoid. And all the other voltages check right. Replace controller.
Gas or electric. Also does it do it all the time the cart is moving or does it do it in both directions meaning if it does it in forward it will do it in reverse when you let go of the gas. Or does it do it constant in forward or reverse.
@@Golfcartwhisperer 48v electric it does it all the time almost like a hovering noise it sound like it’s coming from the motor but I not %100 sure motor was replace once because of the noise and we replace it with a plum motor noise went away for about three months but now it’s back
@@damiansumner8765 yes sir but you need to go down to the mcor and stick your wire leads in the Mcor there to make sure you don’t have a harness problem
@@damiansumner8765 you can’t verify the controller is good until you get the Mcor reading right because that controller needs voltage to put out for speed. Great thinking.
@@Golfcartwhisperer my thoughts are, since the throttle switch is constantly having to move it is more likely to break than having a wire issue on the harness. Thanks for your help.
good day body, i have club car precedent, when i push full the accelerator pedal doesnt running, but in half push it will run, ichange the mcor but still not running when push the pedal full..
@@Golfcartwhisperer mcor is already replalced new one, its happen when i replaced the speed controller, cause the old one is bad, when i push pedal in half its running, but when push in full, cart will be stop.
@@Golfcartwhisperer its only replacement, not original from club car.. cart is running in half push in pedal accelerator, and its good speed, the only problem is when push full the pedal the cart will be stop.
Most of the time it’s caused by mcor over voltage. Even though it’s new don’t mean nothing. Also solenoid can cause this. Or weak batteries. Do you have volt meter
When I push the accelator, the cart just shutters and doesn’t move, doesn’t seem to affect it if you turn tow mode on or off, or forward and reverse, any idea what the issue is?
@@grantmartin4663 it gets a ground if all the other voltages check right going into the controller. Let me know if you have any questions. You could take the floorboard up and bypass the microswitch. In the pedal box. Just let me know if have any questions.
@@Golfcartwhisperer I checked the pedal and everything checked out well. The other problem I found was the red wire coming out the controller only has 15 volts. When doing the test at the end of this video I have no power between the big positive and M- on the controller when hitting the gas ?
@@GolfcartwhispererI had the model number written down but couldn't find it. All the wires and electric components are exactly like this Club Car that you are working on. I have watched another video of yours and checked the accelerator tests. They changed out the controller and drove it for 15 minutes then parked it and then it wouldn't move after that.
@@Golfcartwhisperer no I can't get it to run but thought the blue and bl/w was on incorrectly. I have a 2001 club car ds with regen 2 controller and looks like a new obc, soleniod , and charge port. It does not have v glide looks like upgraded to MCOR or it came stock not sure. The charger turns on when plugged into cart and batteries are good.
What if when u put the red lead on B+ on the controller and black lead on the blue and white wire on the solenoid and when u hit the gas I don’t get battery voltage/ no click in the solenoid. what would be the issue ?
You only explained what would be the problem if solenoid was clicking would be the motor, or the controller. Not if it didn’t have power what would cause that. That’s the problem I’m getting on my golf cart. And when I tested it with volt meter it shows no volts running to the solenoid from B+ on the controller to the blue and white wire on solenoid with the volt meter.
Can someone make a video to show where the solenoid , the main & any other things u r talking about.. please for us ppl that never worker on a golf cart before
Hey GolfCartWhisperer. Can you help? Just got a 2005 48v Club Car Precedent. When turning key on and hitting gas pedal, the cart will hesitate for a second and then not move. Turn key off and back on and try again and it will do same thing. In both forward and reverse. But after a few tries it’ll take off fine and be okay. Any idea what this intermittent thing could be and how to diagnose it? I’m a novice. Thank you!
@@MrLions4life watch this video and do this and let me know. If this fixes it replace More. If it doesn’t fix it, replace the solenoid. Let me know the outcome of the test.
Hey hey hey. Just to let everybody know that if you have no voltage on the blue and white wire on the solenoid. And all the other voltages check right. Replace controller.
Hey golf cart whisperer I have a 2005 club car ds thats making a loud winding noise out the back any idea what it could be?
Gas or electric. Also does it do it all the time the cart is moving or does it do it in both directions meaning if it does it in forward it will do it in reverse when you let go of the gas. Or does it do it constant in forward or reverse.
@@Golfcartwhisperer 48v electric it does it all the time almost like a hovering noise it sound like it’s coming from the motor but I not %100 sure motor was replace once because of the noise and we replace it with a plum motor noise went away for about three months but now it’s back
Motor bearing if it does all the time.
@@Golfcartwhisperer ok thank you we will try that out hopefully it works
I have no ohms on the white and yellow wire. Does that mean I need to replace the throttle sensor?
And I was unable to verify that the controller is good, but I think that’s because my throttle center is bad correct
@@damiansumner8765 yes sir but you need to go down to the mcor and stick your wire leads in the Mcor there to make sure you don’t have a harness problem
@@damiansumner8765 you can’t verify the controller is good until you get the Mcor reading right because that controller needs voltage to put out for speed. Great thinking.
@@damiansumner8765 also man make sure you hit the subscribe button and the like button too. Thank you.
@@Golfcartwhisperer my thoughts are, since the throttle switch is constantly having to move it is more likely to break than having a wire issue on the harness. Thanks for your help.
good day body, i have club car precedent, when i push full the accelerator pedal doesnt running, but in half push it will run, ichange the mcor but still not running when push the pedal full..
@@yhelbeltran7552 hey hey hey either solenoid or Mcor is bad. Do you know where they’re located.
@@Golfcartwhisperer mcor is already replalced new one, its happen when i replaced the speed controller, cause the old one is bad, when i push pedal in half its running, but when push in full, cart will be stop.
@ What type of controller did you replace it with
@@Golfcartwhisperer its only replacement, not original from club car.. cart is running in half push in pedal accelerator, and its good speed, the only problem is when push full the pedal the cart will be stop.
Most of the time it’s caused by mcor over voltage. Even though it’s new don’t mean nothing. Also solenoid can cause this. Or weak batteries. Do you have volt meter
When I push the accelator, the cart just shutters and doesn’t move, doesn’t seem to affect it if you turn tow mode on or off, or forward and reverse, any idea what the issue is?
Have you checked voltage on the battery pack? You’re either going to have a bad battery or you’re going to have motor brushes stuck
@ I checked the batteries and they seemed to check good, how would I go fixing the stuck brush?
@ I’ll send you a couple. Videos go watch
@@StarWarsPigPilot Golf cart motor removal
th-cam.com/video/yfavl-fUMyU/w-d-xo.html
@@StarWarsPigPilot Fix electric motor on Ezgo golf cart
th-cam.com/video/Swo1oycIB_Q/w-d-xo.html
Can you help me. Solenoid got volt when hit gas not starting from zero just volt only. My solenoid not click
Yes sir what years your cart
If you’re still know, it gets voltage when you get the gas replace solenoid. As long as both small posts get voltage.
When I push the accelerator the blue/white wire doesn't turn to negative. Do you know what I should check ?
What year is your cart.
@@grantmartin4663 it gets a ground if all the other voltages check right going into the controller. Let me know if you have any questions. You could take the floorboard up and bypass the microswitch. In the pedal box. Just let me know if have any questions.
@@Golfcartwhisperer I checked the pedal and everything checked out well. The other problem I found was the red wire coming out the controller only has 15 volts. When doing the test at the end of this video I have no power between the big positive and M- on the controller when hitting the gas ?
@@GolfcartwhispererI had the model number written down but couldn't find it. All the wires and electric components are exactly like this Club Car that you are working on. I have watched another video of yours and checked the accelerator tests. They changed out the controller and drove it for 15 minutes then parked it and then it wouldn't move after that.
@@grantmartin4663 what does battery voltage show on the battery pack.
I put the blue and white wires on in reverse will it do any damage
@@jasonjasona1786 what now the cart doesn’t run
@@Golfcartwhisperer no I can't get it to run but thought the blue and bl/w was on incorrectly. I have a 2001 club car ds with regen 2 controller and looks like a new obc, soleniod , and charge port. It does not have v glide looks like upgraded to MCOR or it came stock not sure. The charger turns on when plugged into cart and batteries are good.
any help would be much appreciated
Okay what’s battery voltage
@@Golfcartwhisperer 50.21
What if when u put the red lead on B+ on the controller and black lead on the blue and white wire on the solenoid and when u hit the gas I don’t get battery voltage/ no click in the solenoid. what would be the issue ?
You only explained what would be the problem if solenoid was clicking would be the motor, or the controller. Not if it didn’t have power what would cause that. That’s the problem I’m getting on my golf cart. And when I tested it with volt meter it shows no volts running to the solenoid from B+ on the controller to the blue and white wire on solenoid with the volt meter.
The controller is bad if all voltages are good. Except for the ground to the solenoid. Thanks for the input.
But on my members channel, go into detail about this
Did you get my response
@@dylanjustchillin3483 is your precedent just like the video above or do you have an on board computer
Can someone make a video to show where the solenoid , the main & any other things u r talking about.. please for us ppl that never worker on a golf cart before
Yes I’ll do that for you. Thanks for commenting. Make sure you hit that like and subscribe button for me.
What years your cart. Watch this. Video here and let me know if this th-cam.com/video/N_YghhiXhsw/w-d-xo.htmlsi=_k7WTR4KxfbrVBnM
This is another club car precedent
I am going to make a video right now at your request and will post it within the hour. Thanks for the request
Hey GolfCartWhisperer. Can you help? Just got a 2005 48v Club Car Precedent. When turning key on and hitting gas pedal, the cart will hesitate for a second and then not move. Turn key off and back on and try again and it will do same thing. In both forward and reverse. But after a few tries it’ll take off fine and be okay. Any idea what this intermittent thing could be and how to diagnose it? I’m a novice. Thank you!
@@MrLions4life watch this video and do this and let me know. If this fixes it replace More. If it doesn’t fix it, replace the solenoid. Let me know the outcome of the test.
@@MrLions4life Bypass pedal switch on club cart. (mcor)Common problem#golfcart #ezgo #clubcar#
th-cam.com/users/shortstvW31qlGPmg?feature=share
@@Golfcartwhispererok do the paper clip test in the video you linked?
@@MrLions4life yes
What did you find out
golf-cart-whisperer-shop.fourthwall.com/?source=dashboard
This is my new store. If you need some parts. Or just want to support my page.
K
@@dylanjustchillin3483 in 15 seconds I am going to give you a text Free app number. But once I put I’ll delete in one minute.
@@dylanjustchillin3483 I am deleting that number in 1 min
@@dylanjustchillin3483 did you get the number
What number ?
No 🤣🤦🏾♂️