PCP Airgun: Walther Dominator 1250 Cal. 6,35mm (.25) & Powerupgrades Part 1. Valvemodd.
ฝัง
- เผยแพร่เมื่อ 15 ต.ค. 2024
- Merry Chrismas ! Frohe Weihnachten!
Get more Power for the Walther Dominator 1250 or 850 Airmagnum.
Dosen't matter if you use a 7,5 / 16,3 or 28 Joules Valve.
If you like to know more about this topic check this channel:
Airgun Regulators (Robert Lane)
/ channel
Regulator Adjust:
• Video
more Power from Regulator?:
• Video
bad Regulator Modifications:
• Video
Please check specially :
www.network54.com
www.network54.c...
www.network54.c....
Hope you enjoy the video.
@ john rambo:
Hi,
vielen Dank für Deine Kommentare.
Leider nicht bis 40J wegen dem Mangel an Luftvolumen in der Ventilkammer der 7,5J -Einheit. Genau Deinen Gedanken habe ich in meinem Clip zu Powermodds umgesetzt.
Kann meinen Umbau i.M. leider nicht testen, sonst könnte ich Dir die Frage nach der Leistung (aufgebohrter 7,5J Regulator im Cal. 6,35mm), beantworten.
Die 28 J Ventile gib es z.B. bei e-gun. Liegen bei ca. 160 euro ohne Versand.
Keep lifted,
OD
Hi,
Very good instruction.
How long do I have to wait after applying PETEC on the cap's thread before putting the valve into boiling water ? After 3-5 minutes in boiling water should I take the valve out, wait (how long) and put again into boiling water for 3-5 minutes ?
thanks
Krzysztof
Hi Krzysztof,
thanks for your comment :-)
Sorry, but I think you misunderstood me!
The selant we're talking about (Petec or Red Loctide) is placed on the cap's threads by the manufacturer Umarex/Walther.
To get the cap off the valve, we have to warm up or melt this selant.
Boiling water has only 100 °C so I had to do the "cooking" of the valve twice.
The selant needs some time to become soft/tender, thats why I did the cooking two times.
You can surely do it in one step ;-)
Hope I could help you out.
Peace and Greetz,
OD
ODOG079 Thank you very much !
Krzysztof K
You're welcome, bro' !
Stimmt es, dass das Ventil für ca. 165€ bei 4,5mm auf 28 Joule kommt, bei 6,35mm aber auf 50 Joule?
cedric gregor Ja ..konnte ich auch nicht glauben
Hey Tag auch,
also könnte man ein 7.5J Ventil nehmen und es aufbohren, sodass es dann 40J +- hat? Wäre ne tolle sache weil irgendwie findet man im Web keine 40J Ventile mehr. Thx für das Lehrreiche Video
ps, falls wieder Schnittlauch mitschaut,
Nur ein Büchsenmacher darf änderungen an einer Waffe unternehmen!
ach...
No crony result then? Probably fucked it up