Creative measuring, tape to make a straight line and a SMALL cut off wheel or a ball diamond bit in a dremel tool. No real science to it, i used a dial caliper to mark my end point, connected the dots with tape and drew a line. I just tried to maintain depth as close as i could. Debur it smooth! Just dont have the grooves go off the bottom of the skirt...have them off the side slightly. Off the bottom might create weird wear when the piston rocks in the bore.
Hey, not to be a stickler about what I didn't see... But what happened to using the feeler gauge when tightening the rod caps?? Or was that for doing the Main caps on the crank... Can't remember if it was one or the other...🧐🫡
Will you sell me a crank trying to get turbo motor ready before dune season order payed for a new 08 gsxr1000 crank off Motorsport they took the money no crank been mouths
Thanks I’m copying your motor for my Yamaha banshee I drag race in the dunes I have your rods pistons clutch fuel tech got that from David Lagorri I have 08 head should I use 08 intake cam on intake and a 04 intake on the ex cam for turbo like 105/107 center line
![ตีสิบเดย์ [FULL] | เปิดใจ "อาจารย์ เบียร์ ฅนตื่นธรรม" นักสนทนาธรรมสายดุดัน!](http://i.ytimg.com/vi/vqaBI_mnoDk/mqdefault.jpg)
I like the mod. You mentioned. 020 deep. Can you tell us what you use to create the groove and how you maintain the pattern?
Creative measuring, tape to make a straight line and a SMALL cut off wheel or a ball diamond bit in a dremel tool. No real science to it, i used a dial caliper to mark my end point, connected the dots with tape and drew a line. I just tried to maintain depth as close as i could. Debur it smooth! Just dont have the grooves go off the bottom of the skirt...have them off the side slightly. Off the bottom might create weird wear when the piston rocks in the bore.
If I understand correctly,
The grooves run into the oil ring land and off the side in the void of the side of the piston?
My excuse used to be a lack of TPS videos to keep me inspired and now two have dropped in a week! I'm not worthy...
All are worthy! Getting tacos counts!
Glad I'm not the only one
Ladies....Mom 😂
LOL!
Hey, not to be a stickler about what I didn't see... But what happened to using the feeler gauge when tightening the rod caps?? Or was that for doing the Main caps on the crank... Can't remember if it was one or the other...🧐🫡
Honestly, just didn't do it.
@tpsfab See, I really watch your vids very closely for those small details that you are so good at mentioning! 👍🏿
Will you sell me a crank trying to get turbo motor ready before dune season order payed for a new 08 gsxr1000 crank off Motorsport they took the money no crank been mouths
Im sorry i dont have any to sell. Ive had good luck off ebay from reputable dismantlers
Thanks I’m copying your motor for my Yamaha banshee I drag race in the dunes I have your rods pistons clutch fuel tech got that from David Lagorri I have 08 head should I use 08 intake cam on intake and a 04 intake on the ex cam for turbo like 105/107 center line