ขนาดวิดีโอ: 1280 X 720853 X 480640 X 360
แสดงแผงควบคุมโปรแกรมเล่น
เล่นอัตโนมัติ
เล่นใหม่
She sounds good like a race car good job bud
Turn the idle up bro it’s suffering, you’ll damage cam and lifters if you run a hydraulic cam too low at idle
@@tzon6802 right on lol
Any chance you can give me some more information on the mufflers? Part number?
They were off Amazon. Blackhorse 2.5" single chamber performance muffler
@@fastvsix thank you
How many horses?
How'd your cam break-in go just broke mine in this past weekend same cam
I've had this cam in for a couple years. Just did the normal procedure. I use valvoline vr1 oil. No issues so far.
Sound like timing is off!!!!
@@pops3554 cam was installed with a degree wheel per specs.
She on beat
@@pops3554idle is too low, cam will be short lived he keeps running it like that
what u running for lifters, pushrods and rockers?
Stock rockers. Btr LS7 lifters and trick flow pushrods.
@@fastvsix okay, i didn’t know if stock rockers could handle .480 lift
@@westogarage crap, I was thinking of my other car that's a LS lol.This is a flat tappet cam with comp camps hydraulic lifters and comp cams 1.6 roller rockers. Stock pushrods.
@@fastvsix did you end up going with guided rocker arms or non-guided? The heads I have I can run either or
@@westogarage I had the vortec heads milled for guide plates and went with screw in rocker studs. It has guide plates.
What did this setup run at the drag strip?
12.6 in the 1/4
She sounds good like a race car good job bud
Turn the idle up bro it’s suffering, you’ll damage cam and lifters if you run a hydraulic cam too low at idle
@@tzon6802 right on lol
Any chance you can give me some more information on the mufflers? Part number?
They were off Amazon. Blackhorse 2.5" single chamber performance muffler
@@fastvsix thank you
How many horses?
How'd your cam break-in go just broke mine in this past weekend same cam
I've had this cam in for a couple years. Just did the normal procedure. I use valvoline vr1 oil. No issues so far.
Sound like timing is off!!!!
@@pops3554 cam was installed with a degree wheel per specs.
She on beat
@@pops3554idle is too low, cam will be short lived he keeps running it like that
what u running for lifters, pushrods and rockers?
Stock rockers. Btr LS7 lifters and trick flow pushrods.
@@fastvsix okay, i didn’t know if stock rockers could handle .480 lift
@@westogarage crap, I was thinking of my other car that's a LS lol.
This is a flat tappet cam with comp camps hydraulic lifters and comp cams 1.6 roller rockers. Stock pushrods.
@@fastvsix did you end up going with guided rocker arms or non-guided? The heads I have I can run either or
@@westogarage I had the vortec heads milled for guide plates and went with screw in rocker studs. It has guide plates.
What did this setup run at the drag strip?
12.6 in the 1/4