Thank you! Short answer is I can remember one right now. Thick copper wire Hammer 16 to 20 guage copper sheet (For 16 guague you need to saw out your mushroom circles) Hole punching set for thinner copper sheet (20 to 24 range for gauge) Brass hammer for the dapping hammering and hole punching. Dapping blocks Silver solder (Any kind of solder is probably fine for this since it is one joint) Flux (Any kind you like working with) General files I THINK that's it.
@MaxPowerCrafts remaining tools in curious about. The one used to make tiny hole around 15 min. The torch(i have a yellow map gas torch, is that enough heat?) The pad you are heating on ?
Great video! Subbed! Covid is hard on the hide for sure. What gauge of copper and brass were you using with the cutter if you don't mind my asking? Thanks in advance!
Thank you very kindly! Looking at my old recipts I was trying to use the thinnest stuff I had, but it looks like the thickest could be 18 gauge, but more than likely 20 gauge :)
Love the variety!
Copper is always fun to play with, never know what you’re gonna get
Hope you are feeling better!
I have been feeling much better : )
Love the project! Do you have a "shopping list" for the tools you used?
Thank you! Short answer is I can remember one right now.
Thick copper wire
Hammer
16 to 20 guage copper sheet (For 16 guague you need to saw out your mushroom circles)
Hole punching set for thinner copper sheet (20 to 24 range for gauge)
Brass hammer for the dapping hammering and hole punching.
Dapping blocks
Silver solder (Any kind of solder is probably fine for this since it is one joint)
Flux (Any kind you like working with)
General files
I THINK that's it.
@MaxPowerCrafts remaining tools in curious about. The one used to make tiny hole around 15 min. The torch(i have a yellow map gas torch, is that enough heat?) The pad you are heating on ?
Great video! Subbed!
Covid is hard on the hide for sure.
What gauge of copper and brass were you using with the cutter if you don't mind my asking?
Thanks in advance!
Thank you very kindly!
Looking at my old recipts I was trying to use the thinnest stuff I had, but it looks like the thickest could be 18 gauge, but more than likely 20 gauge :)
Hello sir. What are steel cubes for doming the Blank’s called please.
Those are Dapping Blocks, you can get a relatively inexpensive set from harbor freight!