Improve Rough Idle Chrysler Pacifica Air Fuel System Cleaning 3.6L Pentastar - 25 min - increase MPG

แชร์
ฝัง
  • เผยแพร่เมื่อ 11 มิ.ย. 2024
  • Improve Chrysler Pacifica rough idle by cleaning the Air Fuel System easily at home in 25 minutes. Easy to clean your throttle body, Air Intake Temperature Sensor. Requires 2 tools: Screwdriver or drill with flat head and 10mm socket wrench. I advise having an old clean toothbrush handy (not quite a tool). Video shows how to remove Air Filter cover, Engine Air Cleaner Housing and engine beauty cover to spray cleaner into throttle body to remove residue, dust, debri and a technical term: gunk. My Pacifica is running so much smoother and I've gained 4 MPG after cleaning the Air Fuel System and adding Techron fuel additive for fuel injectors and fuel line. Works on Chrysler Pacifica 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025 with Pentastar 3.6L engine. I recommend using latex gloves when working with chemicals. In video I only put them on when getting int he valve. Do as I say, not as I do hahahaha.
    To clean system you will need
    CRC Throttle Body and Mass Air Flow cleaner twin pack 5.5 ounce each
    amzn.to/3Rp3o8g
    or you can buy individually
    CRC Throttle Body Cleaner 12 ounce
    amzn.to/4c3jkW8
    CRC Mass Air Flow cleaner 11 ounce
    amzn.to/3VDKzQZ
    Chevron Techron Plus Fuel System Cleaner 20 ounce
    amzn.to/4bS9s18
    Any purchase from link I receive a percentage at no cost to you to keep making content for How to Do Stuff.
    I am looking to grow my channel and keep bringing you content of How to Do Stuff. Please subscribe, like, comment and pass along my channel to your friends. Much appreciated. Let's all keep learning.
    #chryslerpacifica #pacifica #idle #howto #diy

ความคิดเห็น • 5

  • @ruley73
    @ruley73 14 วันที่ผ่านมา +1

    It's far easier to remove the entire air filter housing instead of splitting it. The bolt you see in the corner near the left strut tower is all that holds it in. It's also less risky because sometimes the two halves don't like to mate together properly. Specifically, the cut corner side of the upper half sometimes doesn't seat properly with the bottom half. All will seem fine because you won't encounter much difficulty getting the screws back in. I would definitely double check yours. Just make sure the outer flap on the top half is where it needs to be. If someone else improperly reassembled it before you did, the whole housing becomes warped and is much more likely to be incorrectly assembled the next time. You are correct that manufacturers don't use MAF sensors anymore. They use a MAP (manifold absolute pressure) sensor instead like this engine does. The intake air temperature sensor serves a completely different purpose and isn't a substitute for a MAF sensor.

  • @rolanddensonjr2464
    @rolanddensonjr2464 21 วันที่ผ่านมา

    Great video. Clear concise and to the point.

  • @doctordishes2es

    GET RID OF THE CAR CHRYSLER CARS ARE JUNK