ฝัง
- เผยแพร่เมื่อ 12 ก.ย. 2024
- This video explains the method I used to remove the output shaft and bearings from an RC-30 Omni style brush hog gear box. This gear sits on a bobcat brush hog, but is of similar style to many of the brush hog gear boxes out there.
Thank you! This got me thinking and I used an old brake rotor as your 2x4 and 2x4s as the spacer. Mine was rusted inside and it took a lot to get out then a few taps. For the back bearing I used the greasy rag trick. I punched pieces of a greasy rag into the center of the rear bearing and it pushed it out. Thanks again! This what youtube is for!
I owe you an apology and thank you! I thought my puller and tools would work better so I spent 3 hours and 2 bandaids later to finally give up. Then I built your puller and 5 minutes later I was done! Thank you!!!!!
Good video. Thanks
Very clever!
and bearings set
Where did you buy replacment gears?
David, www.ranch-rite.com/farm-agriculture/gearbox-parts.html has gears for the Omni style gear cases.
How did you get the retaining clip out?
I think I wedged a screwdriver to pin one side and kept it from spinning and used a second one to work the retaining clip off. Now that you mention it, I recall it being a pain.
Can you please give details where to get new gears?
George, I purchased these from www.ranch-rite.com/farm-agriculture/gearbox-parts.html.
You aint going to replace the other cracked bearing sounds like trouble for the almost rebuild hoghead
Cut a lot of brush since I did this video. Unit is working perfectly.
HOW DO I GET THE GEAR BOX OFF?
You got to remove the blades first. Then remove the shear pin that connects the hydraulic pump to the gear box. Then remove the 4 bolts that typically hold the gear box to the frame.