Standing Seam Metal Roofing Installation: Bullnose Rake Detail

Review metal roofing installation best practices for the Sheffield Metals bullnose rake detail.
Be sure to subscribe so you don't miss the next installation video!
**********************************
We use our scale model roof deck to demonstrate tips and tricks on how to install the Sheffield Metals bullnose rake detail.
Steps covered:
1. Create and set guide jigs
2. Fasten cleat every 8 inches
3. Seal all joints
4. Fasten bullnose rake every 4 inches
Install fasteners straight and perpendicular to the roof surface.
Ensure all swarf is cleaned off during and after installation.
Clean off remnant chalk lines.
Note that all clips are installed 2 feet on center for this install. Check the engineering requirements for exact clip spacing on your project.
Watch this video to see a fold-over rake detail installation on an actual residential project: • Installing Standing Se...
Please note the installation details and methods shown in this video are for reference only. Sheffield Metals recommends following their published installation details or for WTW projects following the required details issued and marked approved for that specific project.
**********************************
FOLLOW THE SHEFFIELD METALS TEAM
► / sheffield-metals-inter...
► / sheffieldmetals
Visit Our Website: hubs.ly/H0bFCn60
Subscribe To Our Blog: hubs.ly/H0bFYvX0

[@stwdeezul2972]

Is that Dave Stubbs?

[@TheMetalRoofingChannel]

Yes sir! -Thad

[@Annon_Emus]

adding annoying music to videos does not make them more professional
it’s the exact opposite, actually

[@bluegorillacookies]

That was super unhelpful