EGO LM2100SP Self Propelled Drive PCB Replacement

[@MatthewSidun]

I had the same problem, i watched the video and started to disassemble. I removed the cover to start troubleshooting, i noticed that there is a switch mounted on the right side , lokking atitfrom the rear of the mower. I put the battery in and applied pressure back towards the cam off theswing arm for the handle. And the drive motor was working again. Made a wedge and placed it behind the switch to take up the wear. Back in business!

[@SmoothBassVO]

Does this address the problem where it seems to be "slipping"?

[@soupra22]

Did you buy a new pcba or refurbish the one that came with it?

[@soupra22]

Also how do you know if the pcba is bad

[@matterwin8635]

Buy new you can replace the fuse but that is it.

[@user-dx9qx3nm2l]

the 6 screws that hold down the top cover, are they hex or torx, what size bit did you use ?

[@matterwin8635]

torq T20

[@RiotGamingUS]

Hi Matt! I’m having some trouble reassembling my LM2130SP where the power button is, there’s two micro switches there and one of them I can not figure out how it goes. It just seems to be loose and not sitting well any way I put it. Any help would be appreciated. Thanks!

[@matterwin8635]

i will take one apart here and take a video for you.

[@RaymondDeMartini]

So I replaced the PCBA but I don't see where the brown wire connects on my mower. I see the white wire but no red wire on that side. Any thoughts?

[@matterwin8635]

brown should have small wire running to the battery

[@berettaguy7445]

Do these self-propelled mowers use belts like gas mowers?

[@matterwin8635]

no sir. they are a gear drive.

[@berettaguy7445]

Thank you; I wasn't sure.@@matterwin8635

[@Machinekiller00]

Where can I purchase a new PCBA for the LM2150SP?

[@matterwin8635]

if out of warranty coverage e replacement parts is your best bet. 283-083-1001 is the part number

[@danniecarmona2509]

What about a self propelled drive works but low power only no speed change

[@matterwin8635]

could be in the handle broken wire are the pcba that controls the self-drive. ruin the test in the video and see what one.

[@michaelaus7346]

Good video, but kind of vague, most people don't know using heat shrink tubing and putting it on before soldering or how to solder or cut wiring/ connections without making it a headache if they cut too close to a connection. Could be more clear on assuming people have lil skill or just using wiring connectors to attach 2 pieces of wires.

[@matterwin8635]

i do understand what you are saying but theses videos are made for ego Techs so they should have a idea on how to make general repairs.